Forum Replies Created
-
AuthorPosts
-
suedehead1
Participantthats good i will get another look thanks
suedehead1
Participantok thanks for the advice I will go and take another look
suedehead1
Participantits not loosing water or trying to fill it just aborts after washing for 10 minutes
suedehead1
Participantalways worth a try thanks
suedehead1
Participant£25 cheap for a parking ticket, i use one of those voltage pens to check if its getting electricity I have had the same thing before
suedehead1
Participanthi, its a right fancy kitchen belonging to 2 lovely men and a chihuahua I think i will need to have a think but destruction is most likely thanks
suedehead1
ParticipantHi the pump made it quite but on return i noticed the brushes were worn, an amateur mistake
suedehead1
ParticipantThanks i was between the start switch or door lock, whirlpool had been out a coupke of weeks ago and of course it worked.
Nothing worse than an intermittent fault.suedehead1
Participantserial number CB3200769 made august 2022
suedehead1
Participantalso call themselves assure protections
suedehead1
Participanttried it sitting out unfortunately still the same
February 27, 2025 at 7:35 am in reply to: zanussi z816wt85bi washer dryer jumps to 11mins on dry cycle no heat #491564suedehead1
Participantok i will put it into service mode and check rear ntc thanks
suedehead1
Participantok thanks very much
suedehead1
Participantok, i will get the customer to trty running it sitting out thanks
suedehead1
Participanti can get the seal but wasnt sure how to get the old one off sounds like a pain
-
AuthorPosts
