Forum Replies Created
-
Posts
-
Re: rangemaster 110 green
thanks very much i am going tommorrow to fix it,
i dont think i could have done it without this info.Re: Indesit IWDC 6125
these are a heap of shi*e could be anything at all thermistor,
heater, door lock, motor. Emw repair the pcbs I had one doing a similair fault, I sent the main Pcb to EMW it tested ok,
it would be worth sending both boards off to EMW if you can convince the customer to give you time.
I never managed to fix the one i was at.Re: Whirlpool AWM6141/1 Sticks at 1 min
could be either, it happens on the hotpoint machines could even be a wire off of the heater.
Re: AEG T/Dryer noisy??
most likely to be the belt tension pulley,
its the standard wide zanussi one.Re: Whirlpool AWM6141/1 Sticks at 1 min
i find if any machine is sticking at 1 minute it seems to be a heater fault.
Re: DWF415 whirlpool made for ikea
5045174626675 contact reed from connect.
its less than £20 saves any mucking about.Re: indesit carbon brush
Martin wrote:
jimca007 wrote:
I always assumed it was to ensure a good contactYour assumption perfectly correct. :tup:
No tag = no contact and therefore only the spring and the metal guide are acting as ‘indirect conductors’ which will result in overheating and premature failure…….not good. 🙁
and when the brush wears down the spring goes into the commutator
damages the motor blows the pcb and you can sell them a new machine.
