Forum Replies Created
-
Posts
-
Re: crack in hob
the hob had seen better days it wasnt clamped down just sitting in the hole.
the customer was pretty much ok about it and accepted the s*it happens line I am paying her excess on her insurance and she is getting a new one.Re: crack in hob
sorry to resurect an old thread but called out today to an old creda solarglo ceramic hob and a simmerstat was faulty so i changed it.
tried all the plates and it all worked ok.
5 hours later customer leaves a message for me saying 5 minutes after i left the glass smashed.
I havent phoned back yet as i was hoping for some inspiration
or a place to hide.Re: bosch WTE84307GB/08 dryer
apologies for bumping this one but the customer is back on
again with the what are you going to do about my dryer
question.Re: Washing machine fires
saw a bush machine recentlty the pcb went on fire what a mess.
only time i have seen a machine which had actually been on fire
in twnenty years.Re: baumatic dishwasher BDI631
hi,
there was no water in the base, it fills and washes
but after a while the lights start flashing,
do you have a list of fault codes?Re: Whirlpool washer flooding over?
hole in pressure switch tube perhaps,
i believe you have to take the bezel off before the
front comes off.Re: Lamona Integrated Washer Dryer
the fault codes are the same,
you should always check the heater and thermistors
on these, does it pump?Re: hoover DYN10146p
sorry to have to bump this one but was let down by a repairer of modules and now i have to get a new one to dig my way out of a big hole,
Re: SERVIS M6815W
when you check the motor plug there will be 2 wires which do not have a reading between them and any other wires these 2 wires go to the toc if all wires have a reading then the toc is ok its normally 2 wires in the middle of the plug nos 4 and 5.
