Forum Replies Created
-
AuthorPosts
-
SWERV
Participantwow, that’s in bad shape!
Merv
SWERV
ParticipantI found a parts manual for a S10FF 6 series online. Assuming it was the same cooker (looked identical), it had a part code of ZS1845 for the hinge, although it’s not recognised on any of the suppliers.
Kleenmaid said they couldn’t help, but they provided they provided a contact for their agents in Australia, but they can’t help either.Merv
SWERV
ParticipantNot the best image, but I hope it helps.
Merv
SWERV
ParticipantI’ve checked all over the cooker and that’s the only label on it.
There’s evidence that there was a label on the inside of the door, but it’s been obliterated.Merv
SWERV
ParticipantHi Ken,
thanks for the reply.
This only label that is on the cooker.Merv
SWERV
ParticipantThanks Dave. Nothing was coming up on Connect or Aswo, so I have done a part number request with connect.
Merv
SWERV
ParticipantI had one of these last week and it was the door lock.
Merv
SWERV
ParticipantA cupboard door kit is listed on Aswo.
https://shop.aswo.com/aswoShop/welcome.faces#nsearchedMerv
SWERV
ParticipantHi,
all the parts diagrams and parts list are available on the Bosch web page.
https://www.bosch-home.co.uk/sparepartslist/HHF113BR0B/04
MervSWERV
ParticipantHi Dave,
yes I did replace the power module. I did look over the old board for damage, but couldn’t see any obvious signs of damage.
Merv
SWERV
ParticipantThanks Dave.
SWERV
ParticipantSorry, yes I meant the pressure switch on the motor housing.
Merv
SWERV
ParticipantThanks, I visited yesterday.
The customer said that they had tried it several times and it would always display F14 after 3-4 minutes. I ran it before I pulled it out (it’s integrated) and it filled to the correct level and then started washing. It was running for approximately 10 minutes and then it tripped the circuit breaker, which it did twice. I meggered the heater which was ok and I then removed the connections to the heater relay and then the earth fault cleared. There was also moisture around the terminals of the heater relay, although I couldn’t see where it was coming from.SWERV
ParticipantThanks for the info Dave.
January 28, 2024 at 6:08 pm in reply to: Bosch CMA583MS0B/1 Microwave/Combi Oven Tripping & No M/Wave Heat #489374SWERV
ParticipantMight be worth checking for a leaky high voltage capacitor.
I can download the wiring diagram and send it to you if you send your email address. -
AuthorPosts
