[SWERV]

Thanks Jem.

[SWERV]

Thanks Dave.
The start light is on the far left and then it is the programme lights 1 and 3 from left to right.

Merv

[SWERV]

Thanks Ken.

Merv

[SWERV]

Thanks,I did wonder if there had been a mod. I don’t suppose anyone has the mod sheet?

[SWERV]

Do you use ASWO? They have a couple of alternatives that are much cheaper.

Merv

[SWERV]

I am sure I have had this before on a Bosch oven and a Siemens oven and it was the control board that was faulty (the ones with the relays).

Merv

[SWERV]

I sent a board to them back in February, so they were still going then.

Merv

[SWERV]

When you say you replaced them with working units, were the parts new? and if so, were they the correct part numbers for your model?.

Merv

[SWERV]

One thing to check if you haven’t already done so is the fuse on the circuit board.
there should be two, you’ll probably find the 10amp fuse open circuit.

Merv

[SWERV]

Thanks Dave,

[SWERV]

I’d agree that they were extremely reliable and I’ve repaired very few of them over the years.
I have emailed QER to see what they think. Am I correct in thinking that the control boards are no longer available?

Merv

[SWERV]

I saw the manual for the W256, which is very similar and there is also the parts diagram for it.

[SWERV]

Thanks K. I did have a google search and couldn’t find anything of any use.
Thanks for trying.

Merv

[SWERV]

3110119120280166.

Thanks.

[SWERV]

According to the Maytag parts website, the part number is 341241. When that is put into ASWO, it comes up with C00312676. You’ll need to double check that.

Merv

[Author]

Posts