Forum Replies Created
-
Posts
-
Thanks Dave. My email address is keith@hillcrestservices.co.uk
email address keith@hillcrestservices.co.uk
Regards
KeithMany thanks for the replies. The serial number is correct 11824 I always take a photo of the ID plates now. All zone lights are flashing with the E2 error. A parts list would certainly give me a start.
Both the module and the heat pump changed. I ran the diagnostic program and E31 error displayed. I contacted Siemens Tech desk who stated that the fault was on the drying side. This machine has a metal container located just behind the module with an element and a fan which I believe drys the load. I don’t see how this would affect the wash cycle which has no heat? I will need to check the resistance on the drying element which should be 27-28 ohms.
Yes water height appears fine about 15mm above the filter assy. There is another item plugged into the sump with a couple of wires. I’m not sure what it is or what it does. This machine is one of the top of the range all singing and dancing with interior lights. I do get a reading on the ohms meter so would assume its serviceable. I wonder if this is what determines the water pressure to switch the heater on as you suggested! I might just fit a new one to rule it out.
The tumble dryer does everything apart from heat. The water base collection tank was checked with only a little water in it. I did try it with wet cloths in. If it is the module it comes unprogrammed unless you can advise me? Regards Taff
Re: BEKO WMB91442LW 7110841400
Further to the above just put the machine into test mode and F13 is displayed. Does anyone know how to test these brushless motors?
Re: Bosch Dishwasher SMS65E12GB/44
Tried a new reed switch with same result. I disconnected the reed switch and tried again, the machine filled no problem so I have assumed that there is a problem with the control module which has made the repair uneconomical. Unless of course someone knows better?
Re: Electrolux ESL6225 tow beeps error
Thanks Dave, the machine is empty but have checked the user manual, they talk about a blocked syphon? What syphon are they on about, where is it?
Re: Miele Dishwasher G645SC Plus
Many thanks for the response, I have changed the flow meter. I will have a look at the wash pump today.
Regards
TaffRe: Beko WMB81445LW Error F13
Many Thanks Dave, It looks like a motor fault but I will revisit to confirm the F13 Fault.
This handbook is a great help.Regards
Taff
Re: Fischer Paykel Dishwasher DD605H Panel Fuse Blown
Been in contact with Fisher Paykal. Very helpful with this fault. Apparently the if dryer motor has a fault this then causes the control module to fail. If you have this fault then the module and dryer motor should be changed.
