Forum Replies Created
-
Posts
-
Re: Another joke.
I went to get some money out of the hole in the wall the other day. There was a little old lady at the machine before me & she looked quite confused. I asked her if I could help. She asked me if I could check her balance.
So I pushed her over.
Re: Another joke.
A kid came up to me in the street the other day & said “What’s your favourite Tellytubby?”
I replied “Probably the new Samsung Widescreen, you cheeky pr1ck!”
Re: Another joke.
After queueing up for almost half an hour in the chemist last week, I finally got to the counter and the woman looked at me and said, “I’m really sorry about your wait.”
I said, “you’re not so f**king skinny yourself, you fat b1tch”
Re: Motor cuts out Zanussi
Hi.
Have you run the diagnostic program & retrieved the last recorded fault code?
Re: Interested in work for a manufacturer.
Cheers Lee but it appears they are after someone more SW/W/NW/N & Central London than SE London. I could go for it but I have been traveling around the Greater London area for so long now that I am fed up & want something closer to home.
Thanks for the thought mate.
Re: AEG 16830 w/d
Hi.
EF0 is the flood switch. It means water had pooled in the base of the product, raising the polystyrene float, operating the microswich which supplies a permanent feed to the pump, hence it runs all the time.
You may have caused the flood when cleaning the filter perhaps.
Re: Zanussi ZCE7700X hob ring repair advice
Hi.
The screws are I think under the trim that goes vertically at the front sides of the product. The trim should pop off using a flat blade screwdriver.
Re: Electrolux EWX14440W integrated washer dryer wont start.
Hi.
Have you got into diagnostic? If so, did you find the fault code as “Ed4”. This is 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} certain to be a low insulation dry heater.
Re: Lux EWD1409 E36
Hi.
This code can sometimes be due to the wash heater insulation failing. It may just be worth checking directly onto the heater.
If it is ok, the board is almost certainly banjaxed.
Re: Zanussi FJ1254 sticks on wash
Hi.
Have you done an insulation test when it faults? I am wondering if the heater insulation is failing after use. The pressure sensor/switch is wired through the heater so this is a possible cause.
Re: potential risk of fire on a Electrolux cookers
This was released at the end of August. I work for Serviceforce & have done a fair amount of these.
Re: Zanussi ZCE7700X hob ring repair advice
Hi.
Power off first. Remove both side panels, remove screws for hob top bracket (2 each side). Slacken screws for control panel to allow hob top to clear it. Hob top is hinged at back corners. All four hotplates will now be visible & from here you can follow your nose.
