TheSpinDoctor

Forum Replies Created

Viewing 15 posts - 226 through 240 (of 418 total)
  • Author
    Posts
  • in reply to: Tricity Bendix AW1053W program issues #306571
    TheSpinDoctor
    Participant

    Re: Tricity Bendix AW1053W program issues

    Hi.

    Loose motor tachometer, heater or temperature sensor most likely.

    in reply to: Zanussi washer dryer tripping the RCD. #306504
    TheSpinDoctor
    Participant

    Re: Zanussi washer dryer tripping the RCD.

    Hi.

    I know what the water in NW Kent is hard as I live there. Limescale is a real problem around here. Also probably you will find some of that stuff is detergent residue. A boil wash without laundry & half a measure of a quality brand biological powder based detergent periodicall will help.

    in reply to: Zanussi washer dryer tripping the RCD. #306498
    TheSpinDoctor
    Participant

    Re: Zanussi washer dryer tripping the RCD.

    Hi.

    Worktop & back half of cabinet can be removed to allow access to the wash heater at the rear of the tub.

    in reply to: Kupperbush W/D (zanussi) #306527
    TheSpinDoctor
    Participant

    Re: Kupperbush W/D (zanussi)

    Hi.

    E00 means that there are no faults that have been detected by the main electronic.

    What exactly are the reported symptoms?

    in reply to: AEG D4101 Oven #306427
    TheSpinDoctor
    Participant

    Re: AEG D4101 Oven

    Hi.

    The base element is not used during ventitherm fan assisted cooking but it is used on the pizza mode in conjunction with the fan & fan heater.

    in reply to: AEG D4101 Oven #306425
    TheSpinDoctor
    Participant

    Re: AEG D4101 Oven

    Hi.

    Product number please?

    Also, this usually has 3 elements, top, base & fan elements.

    in reply to: Zanussi IZ141 E52 error code #306327
    TheSpinDoctor
    Participant

    Re: Zanussi IZ141 E52 error code

    Hi.

    You may want to check if the carbon brushes on the motor have worn out.

    in reply to: AEG Lavamat 6100 Digitronic Drum Bearings #305717
    TheSpinDoctor
    Participant

    Re: AEG Lavamat 6100 Digitronic Drum Bearings

    Hi.

    What condition was the drum shaft in?

    in reply to: Zanussi IZ161S Not Operating Correctly #299201
    TheSpinDoctor
    Participant

    Re: Zanussi IZ161S Not Operating Correctly

    Hi.

    As you say the reading was 29.5 Ohms, I would say that the triac on the board has blown & unless you know anyone that can replace just the triac, the board would be required.

    On the wires for the circ. pump, it doesn’t matter what way around you connect them.

    Hope this helps.

    in reply to: zanussi zsf4123 #305171
    TheSpinDoctor
    Participant

    Re: zanussi zsf4123

    Hi.

    The triac is on the board & if it is the fault then it means a new board.

    in reply to: zanussi zsf4123 #305169
    TheSpinDoctor
    Participant

    Re: zanussi zsf4123

    Hi.

    Heater resistance is usually about 25-30 Ohms. If this is ok then most likely the heater triac on the PCB has failed.

    Also check the heater for insulation too.

    The sensor is possible but not usually something that fails.

    in reply to: Another joke. #137485
    TheSpinDoctor
    Participant

    Re: Another joke.

    I surveyed 100 women & asked them “What shampoo do you use in the shower?”

    98 of them said “How the f*ck did you get in here?”

    in reply to: Another joke. #137484
    TheSpinDoctor
    Participant

    Re: Another joke.

    A charity panto for paranoid schitzophrenic homosexuals turned to chaos when someone shouted “He’s behind you!”

    in reply to: Another joke. #137483
    TheSpinDoctor
    Participant

    Re: Another joke.

    An alcoholic, a chain smoker & a homosexual are all told by a doctor that if they indulge once more they will die. As they walk home they pass a pub. The alky goes in, has a shot of whiskey, falls off his stool dead.

    As the smoker & the homo walk home, they see a fag but alight on the floor. The homo says to the smoker “If you bend over to pick that up, we’re both dead.”

    in reply to: Another joke. #137482
    TheSpinDoctor
    Participant

    Re: Another joke.

    Why are people surprised about the Thierry Henry incident against The Irish.

    After all, for a Frenchman, putting their hands up has been a national pastime since 1940.

Viewing 15 posts - 226 through 240 (of 418 total)