Forum Replies Created
-
Posts
-
Re: Liebherr error codes for SWTNes3010
Just to put this to bed, turns out compressor seized. Thanks for your input
Steve
Re: Liebherr error codes for SWTNes3010
Thanks for your reply . I will have a look tomorrow if I get chance and report back . That’s most helpful
Thanks
Re: Liebherr error codes for SWTNes3010
It appears that the two dashes just indicate that the freezer is not cold enough. No other error codes are shown . The freezer and wine cooling section are both warm . The compressor appears not to be running . Anyone have any service/ diagnostics for these ? Or know of any common faults that cause this ?
Cheers
Cheers
Re: indesit IS70C tumble dryer
Thanks guys
Dont think I want to go down the angle grinder route, new drum it is then.
Thanks again
Steve
Re: Hotpoint FFA61
Can always use an old piece of fridge stat capillary tube bent into shape of ‘Shepards hook’ couple of inches or so. Hook part over deforst heater and poke rest into centre of hole.
Should conduct enough heat to stop drain hole freezing.
Steve
Re: stoves grill regulator
Does this help
Phase- P1
Load – 2
N1 – P2
N2 – 4
S1 – S1
S2 -S2Steve 🙂
Re: stoves induction hob range cooker model number MODEL 444
Thanks Seamy
Other model number have is a 1100E. (444445387) range style with induction hob
Funny you should say that, as has cooling fans on the back that were rotating very slowly, changed fan control pcb and fans are now up to speed but still shows 3 dashes arfter about 10 mins. Unit was pulled out from wall so plenty of ventilation !.
Have also changed touch control pcb under hob, leads me to think must be induction rings faulty ??? can find no error codes on internet anywhere, basically stumped :rolls:
Can see nothing in instruction manual, may even be something obvious. Help.
Steve
Re: Whirlpool 3RGSC9455JQ Bearing Change
chezza wrote:I usually manage these without any special tools , but if you have a large pair of molegrips , it is even easier than with a lump hammer and drift 😀
Works everytime 😆
Re: whirlpool 3rlsq8033sw0 T/L
Hi Mark
Have changed these on older machine and did not have to fit any other parts. It’s a nice easy job if you have the room to work.
Steve
Re: Zanussi ZWD 1472S
Hi Dave
Cant confirm what has blown pcb but had similar Zanussi machine with no display and machine dead. Turned out to be user interface board. Hope this helps.
Steve
Re: tds online
Hi Martin
This may help, I think you can access from here, but its been a long time since I registered
Steve
