Forum Replies Created
-
AuthorPosts
-
July 10, 2012 at 11:19 am in reply to: how to replace gas grill burner on a GG720 double oven #377967
Washman
ParticipantRe: how to replace gas grill burner on a GG720 double oven
Hi
Thats a job for a GAS SAFE registered engineer to do.
Washman
Washman
ParticipantRe: Admiral Top Loader Washing Machine
Hi
Try this American site http://appliancejunk.com/forums/index
it has some good videos on repairing top loaders.Mike
Washman
ParticipantRe: Hotpoint DH93CX Fan Oven not fucntioning properly
Hi
If you need to help the fan to start running it needs replacing.
Washman
Washman
ParticipantRe: Indesit WF320P Module part no
Hi
Thanks was going on numbers and details supplied by customer.
MikeWashman
ParticipantRe: Problem with ASKO 20003 washing machine (drain pump)
Hi
According to the original service manual I have that model 20003 came out in 1990. Original part no 8054178 control unit and was about £400.00
Washman
Washman
ParticipantRe: Help regarding diplomat oven please
Hi
You need to check the element for earthing fault, with a Megger or other type of insulation tester.Its the only way, a multimeter is no good for checking for earth faults.
Washman
Washman
ParticipantRe: Zanussi Washer Dryer ZWD16270W1 17 months old
Hi
What happens on the automatic drying programs.
These machines were made in 2008.Washman
Washman
ParticipantRe: Hotpoint aquarius wf000 will not start
Hi
The door interlock is probably faulty and needs replacing.
Washman
Washman
ParticipantRe: Bosch Exxcel 7 WAQ28460GB and Gel Detergent
Hi
Some machines do a short fill and pump out at the start, but not sure about this on the Bosch.
Washman
Washman
ParticipantRe: indesit iwdc 6125 uk codes and pcb
Hi
Fault codes are in the Uk whitegoods fault code book
Mike
Washman
ParticipantRe: belling CTC70 hob
Hi
Masterpart list it as £276.34 + vat trade, but out of stock.
Mike
Washman
ParticipantRe: Bosch SPAM 1200 – continually filling with water
Hi
It needs a new water inlet valve, to stop it filling just turn the water tap off.
Enr number required to help you any further.
Washman
April 25, 2012 at 3:50 pm in reply to: whirlpool adg6340 inlet valve and pumping pulsing on/off #373755Washman
ParticipantRe: whirlpool adg6340 inlet valve and pumping pulsing on/off
Hi
Its a corrupt board and needs to be changed , Very expensive.
Washman
Washman
ParticipantRe: Diplomat range oven
Hi
AWS do not recognise this number , are you sure it is correct.
MIKE
Washman
ParticipantRe: siemens IQ 1430
Hi
What is this machine as siemans eshop does not recognise this number. Full Enr number would help.
Mike
-
AuthorPosts
