Forum Replies Created
-
Posts
-
Re: Teka mini kitchen?
i have worked on whirlpool mini kithens quite a few times. The most difficult part is removing it as you have to disconnect the plumbing and cut through mastic around the sink. Once its out they are quite simple to change the hotplates
Re: INDESIT dryer help
its a thermostat fault, this will cause no neutral to pcb, replace the thermostats on the heater
Re: Creda Quick – Disc
i have seen them a while ago at a customer in hampstead. the parts are obsolete, shame because the worktop will have to be changed or modified for a conventional hob
Re: Miele W377 heater element
qualtex have just started supplying a heater for miele (made by irca) so should be ok quality. p/n htr85 for £14.99. Great saving as last time i hade to get a genuine miele element and cost approx £75
Re: Lux – ESL4115 slimline dishwasher – power button
i have bypassed the on/off switch by soldering a bridging wire in place, otherwise its a new pcb
Re: Hotpoint Aqualtis AQGMD149 – F5 Machine is Blocked
it needs to have a few litres of water inside it so the pressure switch can register. if theres no water inside it will not empty out. This can happen if the machine has been tilted back and the filter checked.
Re: montpellier
i sent the forms back but heard nothing. I thought that at least an aknowledgement would of been sent back. it was from dales electronics that approached me initially.
Re: miele T294 C no heat
if there is a small pcb at near the mains filter then this may be the fault. When testing make sure you have wet laundry otherwise it will turn off as well.
Re: Watchdoggin
when i was a franchise engineer for indesit we were told to repair these machines that had self destructed, replacing the tank, weight, lid and what ever else was needed, they refused to replace the machines
