Forum Replies Created
-
Posts
-
Re: hotpoint wml50
i used to work for hotpoint/indesit and yes it is a common fault that you will struggle to cure, they leak from the dispenser area, changing disp may cure for a while but it is the design-as you say not very repair friendly
Re: Neff Dishwasher S54M45X5GB/01 Filling fault
had it on a siemens and it was the flow meter, same machine different brand
Re: Hotpoint CTD00p Tumbl Dryer
i have had this fault also, it was the timer. the thermostats only need changing if the capacitor goes and then there is still power to heater but the motor does not turn and so overheats and blows stat
Re: Hotpoint FDW70 circulation pump
yes you can fit the alternative motor,just remove the solenoid-it is secured by a push on metal fixing, have done it many times on hotpoint/indesit dishwashers
Re: viscount cookers
pc50gw is the model, this is secured from the side and the door needs to be stripped down to replace it-what a pain!
Re: E2 on smeg
on water testing found stainless steel liner had a pin hole so it was leaking into the base, i have now stripped it of the useable components, the motors on these sell for £140 so now have it for any other smeg dishwashers
Re: amica gas cookers
i know what your saying but the coupling needs to have a stop about 15mm into it so the fitting from cooker end tightens on to it with the washer provided otherwise you are relying on the nut part of the fitting to seal gas tight-not ideal and in my opinion not safe
Re: Service Agents Required
i thought that i was set up for gas in EN postcodes, if not please set me up for any gas work in EN and most N (north london) postcodes
regards
rob-washtronicsRe: UK Whitegoods Shutdown & Upgrade
its so slow its unusable-bring back the old format-there was nothing wrong with it
Re: hotpoint ariston lft 114 looks dead
can be the module, if it has burnt out then the heater may have blown it. otherwise may be display board
