[washtronics]

Re: removing statesman xt5-1020 pulleys

i have done 2 bearing jobs for statesman under warranty, 1st one supplied rear half and inner drum, 2nd call only supplied bearings and drum support, just give it a whack with a hammer first then try, had to do this on many indesits too, they use loctite and you need to break the joint by force first. 8)

[washtronics]

Re: Indesit W143S Door Seal

changed loads of these seals on various indesit machines, just use a 3.5mm cable tie in the two rings of the clamp and pull tight-never leak, never had a problem 😆

[washtronics]

Re: Indesit IWC6145S Tank disintegrated !!!!!!!

there was a support brace mod on the 1600 spin machines but didnt do much to stop this from happening

[washtronics]

Re: Indesit Moon door seal to fit

i have changed one, you are best to remove the white plastic inlet system otherwise there are 2 hoses to remove and these are a nightmare to refit so just a new cable tie over the existing white plastic is best, apart from that they are easy-springclamp hold seal to tank

[washtronics]

Re: Bad Beko motors

had a few beko motors where the magnet on the tacho breaks into pieces and so tries to go full speed then errors out 🙂

[washtronics]

Re: AWP510L Fault

one of your customers in en10 told me, you told them to contact me as they needed it repaired urgent-im not nicking your customers! how long have you been doing amica work for?

[washtronics]

Re: AWP510L Fault

yes toni it is the module, i have had this fault on a statesman machine with the same module, how was your trip to scotland? 😉

[washtronics]

Re: maytag

thanks-i now have a part number 35-6465

[washtronics]

Re: awct10l

yep, they sent another motor and this was the correct one 😆

[washtronics]

Re: viscount cookers

i repair viscount for tej in purfleet, i think they are turkish, electric cookers have switch probs

[washtronics]

Re: Best make of van for the job (all rounder)

fiat scudo1.9d had for nearly 9 years great in snow, done 92000 miles great van

[washtronics]

Re: Looking for Gas Engineers

Hi anne
i thought you knew i did gas-you have never given me any gas jobs. i am ready willing and able and of course gas safe registered.
😉

[washtronics]

Re: extreme workloads

same happens to me, yesterday no jobs, today fully booked, nothing constant, if i can get 6-8 jobs a day i will be happy 😉

[washtronics]

Re: A1635 Flashing 10 times with programming unit clicking r

f10 is pressure switch, take off the connector and sqeeze the individual connections to make them tighter

[washtronics]

Re: When is salt NOT salt?

seen it many times before-it sets like rock and virtually impossible to completly remove

[Author]

Posts