Forum Replies Created
-
AuthorPosts
-
wilf
ParticipantRe: Water filled weights?
sounds good but filling without spills and sealing to stop leaks or evaporation is another problem. Plus could you trust some users to remove and safely replace the lid would the manufacturers want to take that risk ?
wilf
wilf
ParticipantRe: When do you work for yourself
Martin is right. I raised a family on this work but today I’m just about hanging in until retirement. If you try going alone make sure you do your research a tip might be to get hold of an old copy of yellow pages if you can and check the amount of adverts then as opposed to now online.
good luck anywaywilf
wilf
ParticipantRe: Cannon C60 EKS base element fitting
right hand side off, not too bad a job.
wilf
wilf
ParticipantRe: zanussi dryer
customer reports machine seems to be working ok so your guess is as good as mine!
wilf
wilf
ParticipantRe: aeg washer
mains supply good pressure both solenoids working
thanks wilf
wilf
ParticipantRe: Zanussi 91452142800 (A/W)
take a thick piece of card or carpet about a foot square. along one edge cut out a slot about 3 inch wide by 7 inch deep slide this in the front of the drum at the 6 o,clock position. slowly revolve the drum and card together until the card is at 12 o,clock.the screw or whatever usually drops into your hand.
wilf
wilf
ParticipantRe: Neff Double Oven
I had the same thing took the oven out of the housing to find it connected to a burnt out 13a plug. this fitted by kitchen fitters. I advised to get an electrician to fit 30a supply and said double ovens draw more than the stated 13 amp when used both cavities at once hence the burn out although not on long enough to take the fuse out..
customer contacted the kitchen fitting firm they told her they always carried out work this way it was perfectly ok and my information was out of date.electrical science dont change do the sums to calculate the load and wire accordingly.
but what do I know wilf
wilf
ParticipantRe: Do you ever wish…..
I’m one of the “hanging on until retirement” after 40 years what else could I do? The younger generation are more computer literate, fitter and adaptable, to pretend I could train to do something else and compete with a twenty something is stupid.
It will be the same or at least similar for the youngsters now in 40 years, it was for my Grandad 50 years ago he was a cobbler.
3174 3314L 1460 1850 1504 3236H L5 L6 etc etc if you know what these numbers mean your in the same boat as me.!!!!!!!!!!wilf
wilf
ParticipantRe: Are you busy?
looking at the meager amount of post over the last few days I suspect that for the rest of you like me work has dried up yet again.
wilf
wilf
ParticipantRe: siemans washer f23
senior moment brought on by customer trying to help.I looked on the door for the enr only to find a sticker saying model no xxxx I said funny there should be more numbers well said the customer thats a second hand door so its doesnt match with what was there to start with……. but her’s the model number written on this piece of paper sorry I havnt got the serial number of course its the enr number!!!!!!!!!!!!!! I need to lie down in the dark sometimes thank goodness its Friday
wilf
wilf
ParticipantRe: siemans washer f23
sorry enr rubbed but model WM14S493GB/01
wilf
wilf
ParticipantRe: All our yesterdays.
has he got a genuine two bob bit to reset the timer ?
wilf
wilf
ParticipantRe: hotpoint heaters
for observation read wallet!!!!!!
wilf
wilf
ParticipantRe: Is this the end of partfinder then?
just got partfinder issue 28 form. so what is this site, I cant find anything under that address?
wilf
wilf
ParticipantRe: zan carbons
look like a c e set can you use the plastic holders and fit new insides out of a standard brush kit ?
wilf
-
AuthorPosts
