[admin]

Re: indeset we16 fault code F05

Thank you Martin, I shall go and have another play with the machine and check the drain opperation . I will all so get the serial number which should help Dave your self and any one else that cares to help me Thanks lads Gaz

[admin]

Re: indeset we16 fault code F05

Thanks for that Dave ,I ran the machine tonight on program 4 and it ran ok right up untill near the end and the F05 came up! thought I had it sorted ! it all so dumped all the water and started to spin . so I think theres more to this than a blocked pump . any way its late and the Newcastle brown needed some help ! I shall be chuffed if you can help Monday thanks Dave ……………….. Gaz

[admin]

Re: Servis Quartz 1100, s/n unknown, drum bracket broken

Hello everybody,
I just wanted to thank Dave for his help in getting us the spider and tell everybody that the machine is working again 🙂
We changed the spider, the bearings and the seal… all together for about 40 quid. It was lots of fun and everything is working fine.
Cheers, Andreas

[admin]

Re: Indesit we16 fault code F03

Top Man!
Well done Eastiman. You were absolutely right with your diagnosis.Stripped the machine down to find a red wire broken away from it’s lucar connector at the heater. Five minutes with some wire strippers and a new connector and the machine is ‘right as rain. I talked up my part to ‘her indoors’ and she thinks I’m a very clever chappie’. Might even get ‘afters following dinner tonight.
Good one my son. Thanks for the tip’
Regards
FB

[admin]

Re: WE16 fault code F-08

Sorry, its an Indesit washing machine
WE16S
Serial CWS0346606

[admin]

Re: Indesit WD12

Thanks for your help our postcode is PO22 7ES .

[admin]

Re: bosch dishwasher SGS5312 – stuck on rinse mode

hi Martin

My Bosche ran it’s quick cycle OK.

Is this prob a sign of impending doom?

Many thanks – if you are near Lincoln I will give you a free firework.

Cheers

Dave

[admin]

Re: Aga masterchef – range cooker

Thanks for all the useful information.
There seems to be so much choice and although originally we were looking to spend between £1500 to £2k, we’re not sure whether paying a bit more will get us a much better cooker. The makes that have been thrown in our direction, in addition to the Aga, are Falcon, Britannia and Lacanche – we were originally going along the lines of Rangemaster but are now more than a little confused!

[admin]

Re: bosch dishwasher SGS5312 – stuck on rinse mode

Hi Martin

Thanks for the info. A prompt response – thanks again.

The machine did as you said.

I reset and ity pumped, then I turned off after 2 min. At start up the rinse cycle did not run – yehay!

I have now set it to run a ‘quick’ to see what happens.

I’ll let you know

Cheers

Dave

[admin]

Re: Sholtes T62G gas hob ignition ignitor block

Thanks for your help. Looks like I’ll have to use some lateral thinking here.

Richard

[admin]

Re: Indesit WD12

Fault is intermittant. There appears to be two flashes when dial rotates round and round and round. Now when the tumble dryer is used, it is tumbling but not heating up at all. Not entirely sure if the wash cycle is heating water now.

[admin]

Re: Indesit WG 1285W Washer.

I did have that problem, was about 18 months ago tho’. The engineer found it and I thought that was the end of the problem!.

[admin]

Re: Indesit WG 1285W Washer.

More like pulled thread, then holes appear all over. Drum been checked, and guard appears O.K.

[admin]

Re: ZANUSSI DISHWAHSER DE6965

I have ordered a new valve from CES
cesexeter@btconnect.com
valve cost about £25 quid, hope this will fix the problem 😆

If its the water management system, how do i unblock it?, is it an engineer job as i have checked all pipes and had a look underneath 😥

[admin]

Re: Indesit WG1130T Leaking

I was planning on using a jubilee clip instead of the spring clip. I use one where the outlet hose is connected under the sink. I’m surprised they aren’t fitted as standard in the washing machine.

Thanks for all the info.

[Author]

Posts