Forum Replies Created
-
Posts
-
Re: White Knight CL767c No heat
Twoten,
is it possible to remove lower plate at rear of dryer to gain access?
Alan
Re: zanussi f1045 will not spin
Simon,
these timers have a tendency to cause that problem.If the tacho is
secure then it’s likely to be the timer.Reconditioned from EMW £39.90 + VAT.Alan
Re: Hotpoint WMA44 door light flashing
Col
by the way, it could still be the module even if there are no blown tracks, but you can try a module from EMW and return it for £5.87 if it doesn’t cure your problem.
Alan
Re: Hotpoint WMA44 door light flashing
Col
have you removed module for a visual? If not I suggest you do, you’ll probably find a blown track.
As Chris said you can get a replacement for £41 inc vat from EMW.Alan
Re: W/pool ADP4400 pulsing?
Hi Chris,
it could be one of those large Askoll circulating pumps,on it’s way out?
Alan
Re: Zanussi TD520 T/D
Jim
easiest way is to split cabinet and remove drum and fit new seal and microswitch. It’s not a difficult job. Just check where the tensioning spring attaches to motor before you remove the belt.
Alan
Re: NEFF W4380X1GB FD7803
Hi Martin,
I was at machine and put it on a 60 degree wash which showed 80 mins on display and let it run for 15 mins. It was heating as the glass was hot, drum action ok and it spun ok. Why does it show 80 mins for all programs though? I told customer to time the actual time for 60 degree and 40 degree washes and let me know. As it is built under, is it possible to gain access to most components by taking off front panel?
Alan
Re: LG GRL207TUJA
Hi Guys,
It wasn’t the solenoid, it was the bar that opens the flap which either allows ice cubes through or crushed ice. There’s a couple of crimped bits on the bar which are supposed to fit either side of a metal clip and stops the bar from moving to and fro. Because the bar wasn’t seated between these crimps, the end of the bar was snagging at the flap end.
Alan
Re: LG GRL207TUJA
Hi Kirk,
I’ll check that out first tomorrow, I think I’ve had that problem once before. Thanks again for the reply.
Alan
Re: PRIMA LIA176 COOKER HOOD s/n 0424 01096
O.K. guys no replies? Does anyone know who makes these cooker hoods?
Alan
Re: bosch classix condenser dryer
Alan,
check the hose from pump to water container, sometimes get debris blocking jet where it connects to container at back lefthand side.Take of lid of machine for access.
Alan
Re: Indesit WIE157s
Cooky,
EMW Electronics will supply board at a reasonable cost.
Alan.
http://www.emwelec.co.uk
tel:- 01159652118
