Allsorts

Forum Replies Created

Viewing 15 posts - 436 through 450 (of 1,356 total)
1 2 3 … 29 30 31 … 89 90 91
  • Author
    Posts
  • September 12, 2012 at 4:58 pm in reply to: Zanussi ZWF1430w W/M #381075
    Allsorts
    Participant

    Re: Zanussi ZWF1430w W/M

    1. Reset the set programme with the SKIP/RESET (8) button and then switch the appliance off.
    2. Press the START/PAUSE (7) and SKIP/RESET (8) button simultaneously and then, holding the
    buttons down, switch the appliance on with ON/OFF button.
    3. Hold the buttons down till the buzzer sounds and the LEDs start flashing (about 4 seconds).

    George

    September 12, 2012 at 4:29 pm in reply to: beko sponsor the fa cup #381070
    Allsorts
    Participant

    Re: beko sponsor the fa cup

    Lets hope they are on the ball then 😀

    September 12, 2012 at 4:27 pm in reply to: dishwasher buying advice #380857
    Allsorts
    Participant

    Re: dishwasher buying advice

    I would go for the eco-friendly ISE D243W Dishwasher which is AAA performance rated and can utilise a renewable source of hot water which can cut the running costs on the dishwasher by up to 50{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} on a normal program and reduce the program time taken by as much as 20 minutes.

    August 23, 2012 at 1:57 pm in reply to: WASHING MACHINE PRICE 1973 #380020
    Allsorts
    Participant

    Re: WASHING MACHINE PRICE 1973

    Yes, but in 1973 you actually bought a propper washing machine… Nowadays, you buy a breakdown that is currently still working.

    George

    August 20, 2012 at 1:22 pm in reply to: Hotpoint C367GWH Diagram needed #379813
    Allsorts
    Participant

    Re: Hotpoint C367GWH Diagram needed

    Alternatively… Does anyone know what type of safety device is fiited for on the grill on this model?

    George

    August 18, 2012 at 9:20 am in reply to: PAYPAL CARD READER #379183
    Allsorts
    Participant

    Re: PAYPAL CARD READER

    The WorldPay Pay as you go Card Acceptance Pilot is not currently available with iPhone/iOS.
    We are hoping to roll out to iPhone/iOS from Q4 2012, and you should check back to this site regularly for any updates. They say.

    August 7, 2012 at 9:28 pm in reply to: PAYPAL CARD READER #379173
    Allsorts
    Participant

    Re: PAYPAL CARD READER

    Yes, you can register your interest on the website.

    George

    August 7, 2012 at 5:52 am in reply to: AEG Electrolux 16830 #379093
    Allsorts
    Participant

    Re: AEG Electrolux 16830

    frankers76 wrote:They also offered £177 for fixing it including parts, call out etc and that it would then be insured for 12 months after this.

    Also, if you intend going down this path, make sure it is the machine that is insured, in full, for any fault and NOT just that repair inparticular.

    August 6, 2012 at 10:07 pm in reply to: Smeg DWI409C #379097
    Allsorts
    Participant

    Re: Smeg DWI409C

    Check to see if the water has started to heat.. if not, there is your answer.

    August 6, 2012 at 10:02 pm in reply to: Liability insurance on recons #378645
    Allsorts
    Participant

    Re: Liability insurance on recons

    The provider is Peacocks insurance and the underwriter is Brit insurance.

    August 1, 2012 at 4:19 pm in reply to: AEG DISHWASHER.. E30 FAULT #209007
    Allsorts
    Participant

    Re: AEG DISHWASHER.. E30 FAULT

    Is there a service Manual for the F65050 91143407700

    George

    July 29, 2012 at 10:33 pm in reply to: 2x H/P w/d enquiries: WD420p Thermostat & WD860G fan motor #378729
    Allsorts
    Participant

    Re: 2x H/P w/d enquiries: WD420p Thermostat & WD860G fan mot

    For the thermostat .. go with the C00115570 160 one shot or the Qualtex TOC27 which is (CLOSE 143 – OPEN 120).

    For the Fan you want C00115553

    George

    July 29, 2012 at 10:17 pm in reply to: Reset information required #378721
    Allsorts
    Participant

    Re: Reset information required

    OK Tim thanks…

    Will try again tomorrow.. Just hope the little sucker works this time as it is not a local call.

    George

    July 29, 2012 at 7:49 pm in reply to: Help Hotpoint WT960 #378725
    Allsorts
    Participant

    Re: Help Hotpoint WT960

    Sounds like you may need a new heater
    http://www.ukwhitegoods.co.uk/search/fi … ineer.html

    July 29, 2012 at 7:42 pm in reply to: Reset information required #378719
    Allsorts
    Participant

    Re: Reset information required

    Ok.. So are you saying that it is the normal 6 o’clock / 7 o’clock reset operation?

    If so, at what point is the spin button touched, as I tried this for a good half hour last night and the machine was having none of it.

    George

  • Author
    Posts
Viewing 15 posts - 436 through 450 (of 1,356 total)
1 2 3 … 29 30 31 … 89 90 91