Allsorts

Forum Replies Created

Viewing 15 posts - 16 through 30 (of 1,356 total)
  • Author
    Posts
  • in reply to: Help!!!..Wiring 03408 9-way switch #435716
    Allsorts
    Participant

    Re: Help!!!..Wiring 03408 9-way switch

    Putting aside the ‘not helpful’ answer; you would need to atleast supply the model number of the appliance.

    Whether anyone can assist you is a different matter.

    in reply to: Repairtech (UK) Ltd – Is this a joke? #434119
    Allsorts
    Participant

    Re: Repairtech (UK) Ltd – Is this a joke?

    I certainly wont be accepting work at that rate unless it is purely to change a bulb… I will await the final hour to see what comes of the complaints…

    Phil Beddoes has finally lost the plot me thinks

    in reply to: LG f1403tds-How to remove detergent drawer ??? #434180
    Allsorts
    Participant

    Re: LG f1403tds-How to remove detergent drawer ???

    Push down where marked on the image, then pull the drawer towards you

    in reply to: Bosch WAS24461GB/15 #433614
    Allsorts
    Participant

    Re: Bosch WAS24461GB/15

    3d sensor at the top rear of the drum.. Goes out of range and causes an out of balance..

    Either that, or the motor itself.

    in reply to: Whirlpool ADG7560/2 851175615911 #433637
    Allsorts
    Participant

    Re: Whirlpool ADG7560/2 851175615911

    Just a thought.. If the flow meter has electrical contacts and those are not sending a signal to the board, effectively the board would think that the flow meter is not there and immediately fault out.. Is it preventing reset for the fact that it cannot detect the meter

    in reply to: Parts prices #428162
    Allsorts
    Participant

    Re: Parts prices

    1. Qualtex & Connect, or Manufacturer – Best stock availability and best prices
    2. Masterpart
    3. Urgency & Availability, Price, Postage, Notification of delivery ie. Text or email with 1 hr slot.
    4. Sometimes every day, sometimes once a week.
    5. Accounts with major players and Card with Manufacturers & others

    in reply to: zzanussi dryer zdc37200w #433562
    Allsorts
    Participant

    Re: zzanussi dryer zdc37200w

    Check the interference filter

    in reply to: Leisure RCM10CRK Range cooker #432094
    Allsorts
    Participant

    Re: Leisure RCM10CRK Range cooker

    Here it is:

    in reply to: 2016 CONFERENCE #430770
    Allsorts
    Participant

    Re: 2016 CONFERENCE

    Please remember to register!

    Numbers are required for catering, H&S etc as usual and takes two mins to do here…

    [center:1o89b4lh][/center:1o89b4lh].
    .

    in reply to: Electrolux EOB846W1 (944250227) Oven Tripping #430004
    Allsorts
    Participant

    Re: Electrolux EOB846W1 (944250227) Oven Tripping

    Have the elements been tested with a megger or similar insulation tester.. including the new one?

    in reply to: Beko wm 74135 w I’ve cleaned out pump filter and #429738
    Allsorts
    Participant

    Re: Beko wm 74135 w I’ve cleaned out pump filter and

    Switch off and unplug.
    Check the connection on the pump…
    Check the connection on the door interlock.
    Check the pump is ok

    in reply to: elux code #429733
    Allsorts
    Participant

    Re: elux code

    what is the pnc

    Allsorts
    Participant

    Re: Bosch Washing machine WIS24140GB works perfectly but err

    That’s the one .. It is under the lid

    in reply to: Bosch SGS56E02GB/35 drainage problem #429721
    Allsorts
    Participant

    Re: Bosch SGS56E02GB/35 drainage problem

    Ensure the cover is over the pump on the inside of the dishwasher… If this is missing the pump will attempt to pump out but the water will go nowhere

    in reply to: Hoover WMH168D Fault Code E08 – HELP #429698
    Allsorts
    Participant

    Re: Hoover WMH168D Fault Code E08 – HELP

    Possibly the motor drive section on the pcb

Viewing 15 posts - 16 through 30 (of 1,356 total)