Forum Replies Created
-
Posts
-
Re: hotpoint Aquarius 1100 WM63
paulbennett77 wrote: i then diconnected the door switch and bypassed it and it still blows the RCD
Leave the door open and switch the machine on… if it still trips the RCD then check the mains cable for shorts and check the power switch itself .. If it doesn’t trip then and the cable for the door switch with the water solenoids disconnected
George
I was wanting to develop skills in refridgeration area (De-gassing, Re-gassing) as I have none at all .. My only skills within this field relate to repairation of electrical parts .. but with what is being said here and the cost involved it seems senseless…
Opinions?
George
Re: Hotpoint Drum/Spider Advise
Yup, Had that one too.. but in that case the drum was damaged, as was the outer drum front & rear… Only thing that was in tact was the bearings 😆
Re: Anybody know what TYACS1 on EWM1000 board is? (Exploded)
New repair to the PCB Repair channel ???
Re: Hotpoint Drum/Spider Advise
Yes, I agree, I don’t normally change the spiders but on these ones here the bearings have worn into the shafts.
George
Re: Hotpoint Drum/Spider Advise
Ok guys… will try with Titanium as soon as I can.. Thx for the tips… hate losing good drums.
Re: Communication Error
Check for blown trcks on the PCB.. Also check the connections on the PCB and squeeze them a little to tighten them but be careful you dont break them.
This is a common fault
Re: Your opinions on a small claim….
aqua_serve wrote:Guys,
The problem I have here is that the customer states that this iplumber said that the work constituted ‘unskilled labour’ and I should have been charging £25-30 an hour. My labour costs are £40 an hour, there is no call out charge and I don’t round up to the nearest hour but to the nearest half hour.
Hi Mark… I would also point out the fact that you have supplied an assistant at no extra cost to them… If I have a need to supply an assistant for whatever reason, I will normally charge for that assistant .. minimum charge 1 hour.
George
Re: Gas Scotland Ltd
Proberbly one of those that get commissions from working as an agency for other firms
George
Re: h/point sealed drums
Maybe someone like Qualtex should have the same drum manufactured with screws… They would make a killing
Re: WEEE directive
Is that for you to dispose of them or for you t offer a service of disposing of them?
Re: Hotpoint WD71 will not start
This could be the interlock itself or the little button on the board behind the start button
Re: Qer for repairs?
Here are some views:
http://www.ukwhitegoods.co.uk/modules.p … hlight=qer
You can find others by typing QER in as a search
George
