Forum Replies Created
-
AuthorPosts
-
AMS
ParticipantRe: Hoover VHD8122 module
Hi Bazza,
Aint got it. Didn’t think I’d need it as I thought EMW would work their magic. The board no is 475540 if that’s any good. If there are different boards for different serial nos, can you give me what you’ve got, part no wise, and when she rings me back with the serial no, I will be able to work it out for myself.
Cheers
AMS
ParticipantRe: Post wm motor
A quick check using the kitchen scales shows it as just about 4.5kg.
Dave
AMS
ParticipantRe: Usefull syringe
£8.40 to me
Here we go again………….!! 😉AMS
ParticipantRe: Lamona HJA3300
That looks like it! Thanks very much Andy.
AMS
ParticipantRe: zanussi spider
I had noticed that too. Masterpart are doing 2 off for £16.50 + vat each. Mind you, 1 off is £41.06??? Very odd.
AMS
ParticipantRe: Snow….
Crashed me van today 🙁 Managed to hit the only snowplough seen in Fife for 2 weeks. Just about every panel damaged. Still drives though 😀
AMS
ParticipantRe: Lux group oven cut out.
Definately!
AMS
ParticipantRe: Lux group oven cut out.
Just because customer reports same symptoms, doesn’t mean it’s the same fault. Probably find it’s the cooling fan thermostat this time.
AMS
ParticipantRe: Creda 48305 fan element
Thanks for the replies guys. Managed to source one locally thanks.
Dave
AMS
ParticipantRe: Creda 48305 fan element
Hi Bazza, tried to fit a 6204370, but the distance between the tags is too small and the length of the tags needs to be longer to get through the double skin. The one you so kindly found on ebay is the correct one.
Ta very much,
DaveAMS
ParticipantRe: HVR VHD814
Came up against this problem last week. Got around it by using zanussi 50265481007 brushes. Reversed the carbons in the inner metal holder and re-used the original plastic holder. Worked a treat.
Hope this helps,
Dave
AMS
ParticipantRe: DIPLOMAT ADP8332 4 BEEPS
Any feedback on this one?
AMS
ParticipantRe: wasted callouts
I don’t think that second bottle of red did you any favours Lee. 😉
AMS
ParticipantRe: Madness!
Try this one:
This is the information box on connections for tumble dryer belt DST1256062009
“This belt has been shortened from 1830mm to 1770mm. This is is due to noise made by the belt in motion. The belt customer will receive will still state ‘1830’ on it but will be the new size. If problems still occur then contact distripart.”
No wonder I trouble fitting it. 😳
AMS
ParticipantRe: New way to replace Bosch brushes.
Hear, hear to that Chris!
Dave :tup:
-
AuthorPosts
