Forum Replies Created
-
AuthorPosts
-
August 5, 2014 at 2:49 pm in reply to: All of a sudden glasses are cloudy, feel “residue” on them #417524
Andy jones
ParticipantRe: All of a sudden glasses are cloudy, feel "residue" on th
Do a service wash, clean filters, spray arms etc. are the glasses good quality and does the cloudiness come off
Sent from my iPad using Tapatalk HDAndy jones
ParticipantRe: Bosch Maxx WFL2450 Tripping Fuse
Almost certainly the element. Will need testing with an insulation tester to be certain
Andy jones
ParticipantRe: Retirement
Spot on gazman. Im nearly 50 now and not sure how much longer I want to keep going at this, nearly 30 years in the trade now and 20 as an indie it is getting harder as years go by
Sent from my iPad using Tapatalk HDAndy jones
ParticipantRe: Baumatic Single Electric tripping RCD…
Probably the element, only way to find out is to test it with a megger
Sent from my iPad using Tapatalk HDAndy jones
ParticipantRe: Bosh WFD2471 washing machine
Sounds like a coin or something similar had caused the damage, would probably need the tub replacing
Sent from my iPad using Tapatalk HDAndy jones
ParticipantRe: Another element question
If you’ve definitely got 240 across the terminals of the element and no heat then the element is faulty
Sent from my iPad using Tapatalk HDAndy jones
ParticipantRe: Safe contractor scheme
Just an update, told the agent I wasn’t prepared to join the scheme and 2 months past the deadline they still call me out for jobs, when I asked if this was going to be a problem there was no comment, can only assume everyone has said the same oh well that £150 saved 🙂
Sent from my iPad using Tapatalk HDAndy jones
ParticipantRe: beko oven
Bekbe263410017 on qualtex. Check cooling fan is ok
Sent from my iPad using Tapatalk HDAndy jones
ParticipantRe: beko oven
There are a couple of toc’s on most Beko cookers that are prone to going. If timer is ok ten probably one of those
Sent from my iPhone using TapatalkAndy jones
ParticipantRe: Panasonic N4-16V washing machine
I even tried an impact screwdriver and the dam thing wouldn’t budge
Sent from my iPhone using TapatalkAndy jones
ParticipantRe: Panasonic N4-16V washing machine
Had exactly that on my own machine ( don’t ask why I got one ). I ended up drilling plastic so it fitted over the screw and sealed it in place. That was ages ago and it’s still fine however not so sure I would’ve done that for a customer
Sent from my iPhone using TapatalkAndy jones
ParticipantRe: Smeg Washer Dryer WDI12C6 Tripping Cut-Out
How about the fan itself. Is that clear of fluff
Sent from my iPhone using TapatalkAndy jones
ParticipantRe: Suspicious tasting coffee…
Did a job at a pub recently and got offered a full English breakfast and coffee. Was gutted I had to turn it down as I was running behind
Sent from my iPhone using TapatalkAndy jones
ParticipantRe: Beko DC7230B
Did you replace the pulley. If not you need to as it’s slightly smaller. Still a tight fit but not too bad.
Sent from my iPhone using TapatalkAndy jones
ParticipantRe: Bosch WAP28360GB
Had one a few months back and Bosch replaced the board under warranty
Sent from my iPad using Tapatalk HD
-
AuthorPosts
