[Andy jones]

Re: Hoover E11 Error Code – Loose wire broken clip

Found it. Connect part no 5045176289939

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Hoover E11 Error Code – Loose wire broken clip

You can get a loom just for the dryer part that includes that connector. I had one the same and someone on here gave the correct part no on connect. Have looked back but can’t see it , will have another look. Part was only a few quid

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Beko WMD78144 Wahing Machine F3

I had one like that and there was a slight blockage in the pressure hose

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Whirlpool oven AKZ151/IX

I’ve had to replace the button in the past, I know it sounds stupid but did you have selector switched to off before resetting. Got caught out like that myself

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Panasonic Washing Machine Help

I take it you can hear the pump working, if yes there’s a blockage probably in the sump hose

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Panasonic Washing Machine Help

Does it connect to the sink trap. If so check there as well, sounds like a blockage somewhere

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Panasonic Washing Machine Help

Have you checked the filter etc?

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Blockage error code – Hoover Optima WMH 148 DF

Air to escape

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Blockage error code – Hoover Optima WMH 148 DF

If you don’t find a blockage check the hose for little nicks that would allow ain’t to escape

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Whirlpool AKZM 755/IX

Can’t seem to find that model no.

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Miele w1514.

Yep done that mate. There was a very slight grooving on the seal but no obvious signs of drum spider damage. She will have to see how it goes

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Miele w1514.

Thanks for that. My concern is why the seal got damaged in the first place, wondering if there is a drum fault. Don’t want to guarantee the seal when I’m not sure if that’s the real problem

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Hotpoint TCM580 Belt not lasting

Twoten wrote:When Replaced the last time the pulley was checked but I will take another look and replace the felts and bearings.
I wish people would listen when I tell them don’t by a Merloni machine!

Lol. Not the best are they.

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Hotpoint TCM580 Belt not lasting

I would mate. Especially the rear felt and make sure the washer goes on the drum spindle before reassembling. Easy for them to drop off. Also check the pulley for ant signs of wear

Sent from my iPad using Tapatalk HD

[Andy jones]

Re: Hotpoint TCM580 Belt not lasting

I would replace them along with the belt just to eliminate that being the problem, personally I always replace them as a matter of course

Sent from my iPad using Tapatalk HD

[Author]

Posts