Forum Replies Created
-
Posts
-
Re: Zanussi fridge not cooling after a move
Agreed , depending on what the fridge is worth why not try finding an engineer in your area and get some quotes? This site has a pritty good search. 😉
Re: Amica AWCT10L Power Loss
I was gunna say had the same kind of problem a few weeks ago. All signed off out the door ,call 10 mins later no power again. Replaced door switch and PCB all ok now. 😀
Re: Bosch Maxx WFL2260 – Rapid tapping when spinning
No the spider is what can best be described as the “drum support”. If you look inside the drum you can see the shape of it inprinted into the back of the inner metal drum. That shape then connects to a shaft that runs out the back through the bearings and out to the belt and pulley. What happens is that with detergent and corrosion causes one,two or even all three “legs” of the spider can snap and let the inner drum move and hit the outer drum causing the tapping noise that you can hear…. HTH
Edit, sorry just to clarify just explaining that i meant by “spider”
Re: AEG module’s – can they be re-programmed to a different
I would test it where it is as Seamy said it could be syphoning….
Re: AEG module’s – can they be re-programmed to a different
Id go and check the heater and mabe the fill rate of the machine. I’ve never heard of being able to re-programme the pcb’s but you never know someone may know better that me.
Re: Bosch Maxx WFL2260 – Rapid tapping when spinning
It could be quite a few different things including concrete weight,bearing spider or it flcoyld be a raised segment within the the motor. Can you upload a YouTube video I could prob tell you from that.
Re: Zanussi ZWD14270w1
Gosh darn it and you posted it before me ! 😉 its hard enophbto get in there first normally , let alone when there is two exactly the same lol 😆
Re: Zanussi ZWD14270w1
Have you checked to make sure its defo not blocked/pump isn’t duff I’ve noticed they don’t always Humm anymore if they are jammed. If it all checks out ok check if you are getting voltage to the pump. Start from there I would say…
Re: Bosch Exxcel SGS43E02GB/45
BennGun wrote:How do I gain access to remove the water heater which appears to be located at the bottom of the appliance?
The long and short of it…. with great difficulty.You have to remove pritty much every body pannel and the base. I would advise getting in an engineer. Are you sure it is the heating element as iv also had dry joints on the pcb before .If you really wanna do it yourself then there are loads of posts on the matter.Hope this helps.
Re: hotpoint washing wrecks kitchen
HHHHHHHHHHHHHHHOOOOOOOOOOOOOOLLLLLLLLLLLLLLLLLYYYYYYYYYYYYY Crap thats impressive!!! :eeek:
Re: where has all the work gone
Well i was gunna ome n here last week and boast abut how busy i was…. But this week its DEAD 😳 !!Ive done two jobs all week and only one booked in for tomorrow??? Just the way it goes i know but it buggs the hell outta me!
You think your going along nicely then it goes dead!!??
