Forum Replies Created
-
Posts
-
Re: Bocsh SHV43A03GB/42 No response from rest
Unlike most customers, this one uses calgon every month which I said was fantastic
Re: Bocsh SHV43A03GB/42 No response from reset
asp11 wrote:Fills up then pumps a bit and contiues doing this with door open or closed…… Problem is all the lights are on every button and the reset isn’t working so it cant be cancelled and restarted again.
Don’t want to change pcb as its expensive but it must be the fault – or is it?
CX has kept up Calgon treatment so the air break will be good, so I’m guessing the pcb is the problem.any ideas please?
Re: Neff intergrated washer dryer V5340 xogb/06 FAULT CODE
I didn’t think to check that actually. Would this be enough to stop the whole machine from working?
Re: Electrulox EOB5360X cutting out totally
Yes dave it is doing it randomly and on the lower setting, this is why I’ve tried to ask for help because it appears such a weird fault! !!
I’m gonna go with both you and Martin though atm as it does seem the most likely reasoning behind the pproblem.
Thanks to you both
BrettRe: Electrulox EOB5360X cutting out totally
That’s difficult one then as its a double oven so it’ll be hardwired but maybe the socket could still be faulty perhaps. It still works most of the time though and it normally does it on lower temps so not that much of a drain on the power supply.
But on the other hand when its working it good, so confirms the machine itself might be ok but why else might it totally cut off then restart a little later?
Re: Lamona dishwasher LAM8601 error message
Returned to this appliance today and followed the test program, which went ok but the error still appears. Repeated the process and still the same…. anything further I can do maybe?
Re: Lamona dishwasher LAM8601 error message
I’ve read through the notes but as it says about “if there exist any faults within the memory”
So if a fault does exist then it won’t proceed with the test sequence!!
Is there a fault code chart available somewhere please?Re: Siemens SN25M230UK/01 ERROR E01
Ok great, that might explain why I’m not able to clear the error code message?
Re: Beko WMB81445lw – No spin
I can’t help sorry as my cx decided against repairs because of the motor cost!
Re: Beko WMB81445lw – No spin
That certainly is some of whats going on AND would explain it not spinning I assume?
Which was the cx complaint – anyway to test it and might the pcb be effected?Re: Siemans condenser dryer WT46W567GB/16 – No heat
That’s great, any help on this will be amazing.
You say “it uses waste heat” but where does the heat come from in the first place? I saw no obvious element in the back panel area or inside, this confuses me. So it must have a load in it to heat (I tried it empty expecting to feel warmth straight away) It was on for about 5mins and I felt nothing warm at all but I did hear a pump/compressor noise. No error code though it just bleeped and stopped
Re: Bosch WVD24460gb/05 Dryer faulty E17
Yeah, the first part is correct but the dryer motor and elements don’t power up, plus I didn’t hear any noises from any pcb relays?
SO am I looking at quoting for the main pcb and fill valve? would this fault have anything to do with the dryer ntc? They do go faulty with some weird errors sometimes?
