Forum Replies Created
-
Posts
-
electrofix wrote:when you say dead is that all lights off / no power at all
Dave
Yes about 5mins into any program the machine just shuts off, no lights, no sound…. must still have power going to it though because if you press the power button it comes back to life….. very strange?
Yes, if I turn it to zero then select another setting it goes for a short time and repeats the same fault
Thanks for your input guys, I’m positive that the float area and the air break system is working properly.
I’m definitely thinking it’s an error within the board, will have a chat to the customer. …….. ThanksHiya Dave – the float system is fine and this model has the full air break with the built-in impeller jug & small pcb, the wires on that are fine and the wheel goes around perfectly ??
No nothing is blocked at all…… and it heats, which is why I did’t suspect the heater…… or can the heater still be at fault even though it heats??
I’ve got a DYN 7144 with similar issues…… on a short 14min cycle it goes great… it fills,heats and empties but comes up with E03 before filling up for rinses everytime. I’m thinking it can’t be the heater as it heats…… any other ideas please?
electrofix wrote:have sent you 3 emails as files are too big for one
as per usual you will have to dig through to find the info as some is relavent some is not
Dave
THANKS again – I shall take a good look
I don’t know how to access the “service mode”……. but the PNC is 914605702-01 SER is 44400034
Thanks Dave
asp11 wrote:
Awesome – Thanks – I’ll return to the cx and try it 😉
Hiya Dave – The door switch and its wiring were fine, so I’m stuck…… chatted with the cx and they might get in the manu or buy another machine BUT they will inform me about what happens, so i’ll keep you posted – THANKS again for you help
