Forum Replies Created
-
Posts
-
Re: LG top loader WTR1071TP LE code
hi Tony,
DE is a door lock problem,
LE is a motor locked problem, it will be loose motor connections, faulty motor or hall sensor and possible PCB fault, hall sensor is a good one to start with.Bob.
Re: Zanussi oven – Error Code 3
model number or product code is required for correct error code.
Bob.
Re: Zanussi ZENB2625 (925886707) Fridge/Freezer
its possible that dampness has entered into the insulation and is been drawn out by the cold vacuum when the door is closed, ensure all door seals are ok and cabinate joints are sealed and thats about all you can do.
Bob.
Re: Hotpoint FF 200 EG Frost Free Fridge Freezer
power loss at some time, just turn both controls off wait 10 seconds and turn them back on.
Bob.
Re: AEG Lavamat 561 Service Manual required
full service manual not listed for that product code, but i do have the parts list and wiring, pm me your email and i will send them.
Bob.
Re: AEG Lavamat 561 Service Manual required
there is a couple of servce manuals available but i will need the p/code to see if its the one you need as there are about 4 versions of that product.
Bob.
Re: lg american f/freezer demo mode?
if its in demo mode a simple switch off the power for 1 min and switch back on and its reset to normal operation.
Bob.
Re: beko tumble drier
the problem is the front seal, when the dryer is on and hot it softens the bonding glue which leaks onto the drum front face, at the end of the cycle it cools and sticks the drun to the seal, next load in and the drum is siezed or very tight and the belt get burnt by the motor pulley, there is a modified seal and drum available. will need the model number for the correct parts.
Bob,
Re: Hoover HCF5176W – R600a charge
55grams sounds about right but it a while since i did one, just watch the backpressure on the gauge and depending on what scale is on the gauge set the evaporating temp to -32c. or -0.6 bar.
Bob.
Re: Beko fridge freeze recall
to check it the model requires the mod kit fitted just go to the Beko site and enter the model no. and serial no. and it will tell you.
Bob.
Re: Replace thermostat in Lec L200G larder fridge
the capillary is mounted in a sleeve and will just pull out, please do this after it has been switched off for 1 hour or it might be frozen in the sleave,
as for a replacement you will find that the ranco and danfoss generic replacements have the off position at 90 degrees off set so you will have to recalibrate the thermostat dial.
for a genuine part try here http://www.gdhaonline.com/for safety plug out first.
Re: Siemens SN25M830GB/01
(The electronics detect an increased load on the drain pump and
switch it off. An error code is saved in the electronics.)taken from the service manual, i would be checking the drain hoses and outlets, as it looks as if its error is at the end of the pre wash empty cycle.
Bob
