Forum Replies Created
-
Posts
-
Re: Hotpoint FF72
hi monkey,
loads of info available in the public forum on this fault.
change both freezer thermistors and check the fridge door for correct interior light operation and its sorted. 😉
Bob.Re: cannot identify this washing machine??? details below
hi tel
i also have one in stock and im a bit closer than brian and im sure he wont mind 😉Bob.
Re: SEME & Qualtex
Hi All,
the story that i heard many moons ago when i was just starting in this trade, the two partners of south east midlands electronics had a fall out and both started trading as SEME, when one took the other to court for using the same name, one ex partner told the judge that his SEME stood for small elephant mammoth elephant and he showed the judge the logo to confirm this and the case was thrown out of court. as to which company is still trading i dont know, but i believe this story to be true (honest judge) 😀 .Bob
Re: Caple telephone number
Thanks Greg,
its a race between you and Bryan (r600a) to come up with the goods, 😀Bob.
Re: Caple telephone number
Hi Greg,
its the build in double oven range and i am after the service bulliton about the modification to stop the safety thermal cut out from tripping after the main oven has been on for 45 mins.Bob.
Re: LG wm1480fhg LE fault motor!
hi,
its normally the hall effect sensor on the motor that causes this fault, it is part of the motor assy, but on that note i have at one time been caught out and it turned out to be the PCB 😳
good luck.Bob.
Re: PCB module for Hoover/Candy
hi ianforrest,
how long did you leave the appliance switched on, as it can take up to 40mins to restart the compressor after switch on if the evaporator is still frozen, as the appliance enters a defrost cycle at start up.
Bob.
Re: EPROM
Hi Robbra,
the eprom is the programable part of the pcb it holds the instuctions for the microprosser,in the case of a washing machine the wash sequences, as for what an eprom is try the link below.
Bob.
Re: Hoover fridge freezer HCA300FK – PCB
100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} pcb fault
the .100uf yellow capacitor has failed.Bob.
Re: Arrow built under cooker door problems
Hi Squidge
some of the arrow/teba ovens required a pin to lock the hinge in place before you removed the door, they did come with the appliance but no doubt they have been lost, two small wire nails abt 1 ince long will do the trick. open the hinge using a towl to stop it hurting your fingers and be careful not to trap your fingers, when fully open you will see a small hole, just insert the small nail and repeat for the other side, refit the door take out the nails and you are sorted. 😀good luck 😉
Bob.
Re: Panasonic NNT535 Microwave
Hi Ade,
the part you are describing sounds like the cavity cover and should not be removed, is it a buff coloured rectangle.Bob.
