Forum Replies Created
-
AuthorPosts
-
cab
ParticipantRe: beko fridge freezer american style ap930x
Thanks will look it over later.
Cheers
cab
ParticipantRe: beko fridge freezer american style ap930x
lerch do you have a service manual I posted last month for some info, I tried to get into the freezer compartment but could figure out how to remove the ice maker etc without breking anything which seems impossible on this machine
cab
ParticipantRe: Smeg DWI 409C
not sure for the machine you have, but some smegs do this if the rinse aid dispenser coil is open circuit
cab
ParticipantRe: Smeg DF614WE pcb with brain freeze!
are the bits fitted correctly? If it worked before you changed the plastic stuff it would be very bad luck for it to fail, more likely the button frame thingy is permenently depressed, remove it reassemble it and try again.
cab
ParticipantRe: ZWD 16270W Cleaning Condenser
Lid off, remove dryer fan assy, take off the cold fill hose put it into the top of the duct and turn the water on, blast it through to the filter!! 😆
Merry Christmas everyone
Cliff
cab
ParticipantRe: Diplomat ADP8342 Dishwasher, no power
broken wiring through door perhaps!
cab
ParticipantRe: Smeg DI612Ca
you have mail!!!!
cab
ParticipantRe: beko american style
I have seen a couple both had fill valve problems, not very well built, the user board, like most others is clipped onto the door, but all the lugs break off when you try to remove it, not sure who makes them.
cab
ParticipantRe: Leisure Roma RM10F
back panel off, thermal fuse clamped to back of oven cavity
cab
ParticipantRe: zanussi ZX99/5W
you have mail 😀
cab
ParticipantRe: Samsung Q1433S Door Handle

cab
ParticipantRe: FAGOR FUS3611 IT
totally dead is normally the pcb which fits on the right side.
cab
ParticipantRe: Zanussi ZWD1260W
possibly pressure system problem? have sent you mail
cab
ParticipantRe: Samsung Q1433S Door Handle
Hi I also have done one today, the rubber fits onto the door hook, over the bit the handle locates on to and the shim fits on top of the rubber, there is a cutout on the shim whichs locates on the bit therubber fitted onto and on the hook there is a small tang which the shim goes under, got it!!!! :rolls:
cab
ParticipantRe: AEG Favourit 44050VI i/d/w.
have you ran the diagnostic? do you need a service manual?
-
AuthorPosts
