cab

Forum Replies Created

Viewing 15 posts - 106 through 120 (of 423 total)
  • Author
    Posts
  • in reply to: zannusi dishwasher dws909al #303217
    cab
    Participant

    Re: zannusi dishwasher dws909al

    there was a mod which does away with the valve which is connected to the pressure system and is replaced by two inline valves.

    in reply to: Zanussi Condenser Dryer #303236
    cab
    Participant

    Re: Zanussi Condenser Dryer

    5647 12 10-90 / 8 O-ring,Ø 9,25 mm
    5647 12 11-00 / 5 O-ring,Ø 17,86 mm

    in reply to: CAPLE WMI2001 #302992
    cab
    Participant

    Re: CAPLE WMI2001

    From memory this is a Fagor, the pcb does need configuring.
    fo1 filling
    fo2 drain
    fo4 door
    fo5 ntc
    fo6 no heat
    fo7 overfill
    fo8 motor
    fo9 motor inversion
    fo10 internal domotic error?
    fo11 external domotic

    co3 imballance

    in reply to: Door seal retaining spring pliers #300837
    cab
    Participant

    Re: Door seal retaining spring pliers

    LG. Get a piece of cable and tie it around the end of the clamp with the hook on it, loosen one of the weight blots at about the 10 o`clock position, wrap the wire around the bolt and tighten this gives you a free hand to pull down the other end.

    in reply to: Door seal retaining spring pliers #300831
    cab
    Participant

    Re: Door seal retaining spring pliers

    PROVIDING YOU DONT HAVE FINGERS LIKE CUMBERLAND SAUSAGES IT CAN BE DONE!

    in reply to: Door seal retaining spring pliers #300827
    cab
    Participant

    Re: Door seal retaining spring pliers

    the ones supplied to us when we did the AEG/Electrolux stuff, were a pair of external circlip pliers with the points widened to fit the clamps, its seen better days!!!!

    in reply to: zanussi zwf1237 e80 #299724
    cab
    Participant

    Re: zanussi zwf1237 e80

    If you have changed the pump the onlt things left are wiring and pcb for the E80 codes

    in reply to: How to change door seal (Zanussi) #264082
    cab
    Participant

    Re: How to change door seal (Zanussi)

    It is tight but it can be done providing our dont have fingers like sausages!
    The training (years ago) for getting the clip back onto the drier duct, suggested a piece of narrow copper tubing slightly flattened at one end to make it fit over the two ends of the clip then twist.
    Or just use rogues point 9

    in reply to: Zanussi WJD1257W. Sticks at 26 mins. #260941
    cab
    Participant

    Re: Zanussi WJD1257W. Sticks at 26 mins.

    auto syphoning?

    in reply to: van bumper repairs #260189
    cab
    Participant

    Re: van bumper repairs

    Thanks Martin was going to have a go myself!!!

    in reply to: zanussi fle1015 w/m #240984
    cab
    Participant

    Re: zanussi fle1015 w/m

    check the drain pump, after the door locks the pump should run before filling, s/c pumps can blow the pcb.

    cab

    in reply to: Hugh’s chicken run #239237
    cab
    Participant

    Re: Hugh’s chicken run

    before becoming a whitegoods engineer I used to maintain machines that caught these birds and at first I was appaulled. But when you think that they are bred for human consumption the process isnt that bad and I have followed the process from the chicken shed to the shop and any bird that is deemed not for human consuption is not processed.
    Allthese programs are designed to shock the public, chickens,cows,pigs, sheep and even fish are factory farmed so we can continue our carnivorous cravings.

    cab

    in reply to: White knight 84aw dryer #239520
    cab
    Participant

    Re: White knight 84aw dryer

    sensor dry machines suffer from the sensors on the drum paddles getting coated with fabric conditioner and especially drier sheets, bounce, tumble fresh etc.

    using white spirit vinegar, moisten a soft clothe and wipe the drum paddles, the customer should do this regularly.
    also do the same on the band that the carbon runs on that should solve it.

    cliff

    in reply to: Moffat ESC 5061w cooker #239317
    cab
    Participant

    Re: Moffat ESC 5061w cooker

    342 75 11-02 / 1

    CAB

    in reply to: Fisher & Paykel DD605HSS #238970
    cab
    Participant

    Re: Fisher & Paykel DD605HSS

    thanx chris

    cab

Viewing 15 posts - 106 through 120 (of 423 total)