Forum Replies Created
-
Posts
-
Re: Siemens SE26T251GB/07
I appreciate your comments but am no further forward. I’ve replaced the pressure chamber assy. which comes with new microswitches. The new heat exchanger fills to the brim but doesn’t release into the cabinet, so if I abort the cycle and reset it adds just a squirt then stops . I don’t think the machine has been touched before as customer was singing it’s praises, no problems for 6 years!
Re: BOSCH SRS4302GB/10
Don’t think so, as it does it on test, with no detergent or crockery every time.
What was the Bosch mod. Can you tell me?
I’m beginning to think it’s Module fault as everything test ok.Re: Beko drcs68w
Did you ever find the answer to this? I’ve been to one doing exactly the same. Everything seems clean and clear and fault occurs on timed or sensor cycles. Any clues please.
Re: AEG electronic oven temperature problem
Had similar faults on Hotpoint and Miele in the last couple of weeks. Referred them back to manufacturers. As you say, parts are expensive and if you’re wrong…..
Re: BOSCH WVD24520GB/01 Drying fault
Thanks guys for your advice. Paul got it!. Although there didn’t seem to be a blockage, on removing the condenser unit and flushing it through, out came about 4 handsful of fluff. Once cleaned, all OK.
Re: Bosch WAE24363GB/05 1 min left
Yes, first thing I did. Customers has confirmed after several washes, it’s not skipped a beat.
Re: Bosch WAE24363GB/05 1 min left
Insulation on all components fine .Because machine had been on for a while everything was warmed up, so I think it would have shown up. Customer has used machine since and says it’s OK. Seems odd though. Maybe it was the pump after all.
Re: Miele W304 seems to be stuck on LED function test
I’ve tried both programming and service mode. There is no control over what happens, I think the electronic has failed! I just wondered if anyone had seen this happen before.
Re: Internal wiring for Rangemaster all electric range
Thanks guys for your input. I’ve contacted Rangemaster and am waiting for a call from them. It appears that there is no complete harness, just various sections. The guy I spoke to is looking into getting a complete harness, no promises. I don’t think replacing individual wires is an option as so many are damaged!! Apparantly the little beasts use the insulation for their nests.
Re: Bosch SGS43E02GB/45 unable to load new board
Bosch have carried out mod so job sorted. Thanks for your input.
Re: Servis M6011 filter body
No this has a hole in it where the counterweight has chafed against it after the LH tub spring broke. Seems odd that tub spring is available but not the filter housing. Carried out temporary repair, so the machine is working for now.
Re: BOSCH OVEN HBN43N551B clock flashes fast
Customer has decided to wait on repair, so I can’t tell for sure, but I’m pretty certain the clock is at fault.
