Forum Replies Created
-
Posts
-
Re: zanussi zwf16281w 914522520/00
the E50 doesnt really, that code relates generally to a motor fault or pcb pump/filter problems would normally be in the E20 range or E10 poor drainage if i remember right out of balance are usually EF codes
Re: zanussi zwf16281w 914522520/00
whilst you are reading error code you need to press the same 2 buttons used to access diagnostics that will clear code, then turn to off then on then off again it should then be back to normal after you have fixed the fault that is
Re: Zanussi ZWD16270W Wierd Fault,
Hi the ED4 would have been the dryer element whilst in diagnostics at tenth position press and hold the start/pause button and button next to it should clear last error code and reset back to E00.
Re: Zanussi ZWF16070W1
You are right there Mrtin that is the lock that is supposed to be on these machines but some also had 3792030169 and to look at is adifferent beast it is a long shape and white in colour and all these locks played up by not releasing the door at the end of the programe on machines with a display they just sat with 1min on the display sometimes you could trick it into opening by putting it back onto a spin cycle and mostly would open, but yes that number you put is the number i was thinking of
Re: Zanussi ZWF16070W1
Hi mate sounds like the door lock have had problems with some of these there was a new lock out to replace these for that fault.for the life of me cant think of the part number if i find it will post it
Re: aeg w/m will not start
have you checked that the impellor hasnt been jammed very prone to that happening
Re: electrolux d/w ESL66010
yes mate will be one or thr other i would start at the heater if it isnt that then pcb will be the prob heater is the cheaper option sorry havnt got any idea on price for pcb though if you have the pnc i can get you the part numbers though
Re: Zanussi ZWF14070 fills and stops
Hi i would def go into diagnostics but i would be looking at the heater diagnostics would prob be E69. Hope this helps
Re: AEG D8800-4-M Double Oven
Hi mate have you checked the elements for earth fault have had elements down to earth and picjking up a neutral and just carry on heating check all three in the main oven just a thought
Re: electrolux ewx14440
No it dosnt usually show one you will have to go into diagnostics and see what is listed
Re: electrolux ewx14440
Have you gone into diagnostics, sounds to me like it could be the dryer element at fault meggar it out and see the results i am sure anything under 40 ohms will be the cause if so just to make sure disconnect dryer element and see if it cures prob poss error code would be ED4
Chris
Re: electrlux ewf14108w
Hi mate E58 is
wiring defective on invertor for motor, invertor board defective, abnormalmotor operation (motor overloaded), motor defective.i would double check the wiring going into the invertor board i have had the wires unplug from the boards on occasions
hope this helps
