[chris211]

Re: meggers

could you pop one in my box too martin

[chris211]

Re: AEG 57700 T/Dryer no heat

does this dryer have thermostat above the door in the drum these are very prone to going if you stick your head in the drum it is situated at 12 o clock cant get the model number you posted to come up on tds

[chris211]

Re: EWX14440W

Hi any fault codes listed in diagnostics and have you checked the dryer heater they are prone to playing up

[chris211]

Re: AEG COMPETENCE OVEN

pull oven out sometimes they have rating sticker on the top of the oven as well

[chris211]

Re: aeg dishwasher

yes both sides come of it sounds like it prob is the outer manifold which connects to the heater if you are lucky there may be a removable rear lower panel that will give good and easy access but i`m affraid you have no choice but to pull it out

[chris211]

Re: Electrolux EWX14440W washer unlisted fault

Hi i think you will find it is the dryer element that is at fault way to double check is to disconnect wires from element and try it then 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure that is fault

[chris211]

Re: AEG 16800 Washer/Dryer

you need to go into diagnostcs to confirm the actual code but most e40 codes are usually down to door problems ie e41 door open

[chris211]

Re: Zanussi ZWF 1221 Moulded drum. Bearings gone.

Hi Andystu,
as far as i nam aware you cannot split these tubs,the part number for the replacement welded tub is 3484158104

[chris211]

Re: ed4 – new zannussi/electrolux W/D

ed4 is dryer pcb or main pcb but it is always dryer element check for earth faults on the dryer element if in doubt disconnect it from machine it will ork as it should do

[chris211]

Re: jlwd1406

went to one of these a few weeks ago same code dryer element at fault i wuld start there, check for earth fault on element

[chris211]

Re: electrolux w/d model EWX14540W

i would check out the dryer element they are very prone to causing all types of faults especially the type described

[chris211]

Re: Zanussi WD1627OW

check for fault codes in diagnostic if it showing ed4 it will be dryer element they are very prone to failing and bring up sorts of faults

[chris211]

Re: ElectroluxEWX14440W w/m

the problem with this is the dryer element has gone down disconnect it and the machine will run fine untill you get new element for it

[chris211]

Re: Beko WMA620 Out of balance Sensor

it is nearly always the pcb on these machines i would also remove the eco ball as well, they have been playing up on these machines as well

[chris211]

Re: beko WMA1715

Hi mark did i not do you the disc with the diagnostics for the beko machies that should tell you how to diagnose the faults

[Author]

Posts