Forum Replies Created
-
Posts
-
Re: Zanussi E40 fault
follow fill valves wiring back to board two tiny triac on board above connectors.one pre wash and one main wash.have had a couple of these go.have to look very closely for tiny hole in them.diagnostics on tds disc.paul
Re: Whirlpool Commercial Toploader
phidom i have a training manual for these that i got on here last year.the info is very good.if you still need it let me have an email add.paul
Re: does anyone do ghd straightener repairs
thanks for that don.still getting my head around the search facility at mo.think i wiil stock up on ghd spares and give it a go.handy evening work.thanks again .paul
Re: w/pool awoe9558 f13 code
thanks for reply,customer cannot open door at end of cycle.said f13 came up and then m/c goes completely dead,no display whatsoever.
Re: fagor LFU 65 IT flooded now wont work
had a look at same model last week.symptoms the same ie two clicks but no water ingress.felt machine not resetting when trying to change program so put 4 pints of water directly into m/c to see was it stuck mid program, m/c went straight into wash mode and finished program.cust texted to say m/c still going fine.paul
Re: candy f112/3 door handle brackets
looking at pic of handle i think martin is right about handle fixing to top of door.brackets as she calls them are the fixing lugs with holes. handle is a one piece job.paul
Re: candy f112/3 door handle brackets
thanks for reply. this job is about 35 miles from me and ladys explanation a little vague.im thinking handle as you say is on top of door as it as she says holds outer glass in.she explained that bracket on one side of handle broken, only to text later to say both sides are broken. i do this area mondays and thursdays so was hopeful of going equipped thurs.paul
Re: hotpoint wt 740p
had a look today meggered element all good ntc showing 25k at room temp.cleaned all connections on module and one on control board.checked pr sw all good. has rang to say has completed 2 washes.hope it was bad conn and not sticking relay that will come back and haunt.thanks for all the help. paul
Re: hotpoint wt 740p
got to look at this one tomorrow.lady rang up to say m/c showing f08.heater pr sw etc.stops mid cycle. obviously will go have a look for usual suspects but what really bothers me is the fact that her daddy has had a look at it before me :eeek: and i was hoping to go fully armed with wiring diag etc.m/c belongs to daughters friends familly so its hard to refuse it.paul
