[clyde]

Re: BAUKNECHT GSFP 3988 stuck in demo mode ! HELP !!

Give us the serial number and 12 digit production number that are found on the rating plate.

Clyde 😆

[clyde]

Re: indesit washer

When the dial is clicking round the light will be flashing a certain sequence eg 5 flashes then a pause then another 5 flashes. let us know how many your getting.

You’ll find the model number on a little sticker behind the door.

Clyde 😆

[clyde]

Re: Indesit times 2

Kenny wrote:

Also been told about an Idesit that will do the wash program untill it reaches the spin cycle. Then the programer hunts round.
Told them to reset the programer but this has had no effect. Any thoughts?

The dial clicking round doesn’t apply to your machine – it’s for newer appliances than yours.

As Martin suggested check the connections to the module for signs of burning.

Pull the plug out first :plug:

Clyde 😆

[clyde]

Re: LG GR409GPA Frost Free-Fridge compartment not working

osric wrote:❓
I am also unable to use the temp controls at the top.

Sounds like it could be an electronic fault – but only an engineer can provide a full diagnosis. Look in repairs@ for a local engineer or pop up your postcode.

Clyde 8)

[clyde]

Re: Oven Door Glass Replacement – Neff

Try this link

http://www.bshappliancecare.com/Bosch/boschspares.html

Clyde 😆

[clyde]

Re: Quick Bosch Dishwasher Question

Hi Ian,

You can get an instructon manual by clicking this link;

http://www.bshappliancecare.com/Bosch/B … anual.html

Just a guess but it could be a delay timer

Clyde

8)

[clyde]

Re: Indesit WD12X

Dazzler,

There’s normally a reason the paddles break off, most times i’ve replaced paddles in machines i’ve found coins and other random items between the drums or in the filter,

the plastic lugs off the paddles will end up inside the filter area so have a quick check – (the filter is bottom right behind the plinth)

Pull the plug out first :plug:

Clyde 😆

[clyde]

Re: Error code E1 on Hoover new wave plus 5 auto washer

Let us know how you get on with your plumbing

Also quite a few machines have an eco ball in the sump hose/filter assy – It’s there to stop detergent loss when the machine is filling up

Clyde 😆

[clyde]

Re: Error code E1 on Hoover new wave plus 5 auto washer

eastlmark wrote: The conditioner compartment has its own valve coil so this could also be the problem.

You did mention in your first post that it worked ok till it was due to take conditioner,

Penguin45 has covered all other possibilities

Clyde 😆

[clyde]

Re: hotpoint wma42n

I would have a look at the board, i had one recently door lock flashing and wouldn’t lock – the pcb was blown.

Clyde

[clyde]

Re: Miele Hydromatic w736.

Hi Razvanos,

Try and contact Miele direct:

info@miele.co.uk

http://www.miele.co.uk/

they should be able to help you out .

Clyde

[clyde]

Re: Error code E1 on Hoover new wave plus 5 auto washer

E1 on hoover refers to it timing out when filling up, heating up or draining.

Have you checked the filter? a common cause for drain problems is coins getting stuck in the sump hose/ filter housing.

Pull the plug out 1st!

Clyde

[clyde]

Re: Creda 37747 Condenser Tumble Dryer

It should be a 7UF according to the manual

http://shop.ukwhitegoods.co.uk/washing- … -capacitor

Clyde 8)

[clyde]

Re: Ariston Margherita 2000 – I also have a problem!

When the dial is clicking round the power light will be flashing. Count the number of flashes it will pause briefly then keep repeating the code. The amount of flashes indicates an error code.

Clyde 😆

[clyde]

Re: Indesit DI 62 Fault Code

If your plumbing is ok and the dishwasher isn’t siphoning;

It’s time for an engineer to take a look – pop up your postcode or look in directories for a local engineer.

Clyde 8)

[Author]

Posts