Forum Replies Created
-
Posts
-
Re: Strange fault on Indesit washing machine – stumped!
Is the comet issue nylon hammer no good for working on these?
Clyde
😆Re: Indesit DI 62 Fault Code
Light 3 (rapid wash) flashing quickly is a drain fault!!!! sorry!
all i can suggest is check your plumbing.
There are a couple of different versions of this model, we may be able to help more with a serial number and production number found on the rating plate.
Clyde 8)
Re: Indesit Dishwasher D63 stuck in Cycle
Hi
Your dishwasher sounds like it has develpod a leak, unless your filters were blocked before the appliance went off it’s time for an engineer.
Look in directories or pop up your post code in here
Clyde 😆
Re: Asian Crisis
Donations can be made online just click on the following link;
Cheers
Clyde
Re: help!electrolux error code
The manual does list an error code EF0 – this could be a draining problem or excessive detergent (too much foam during drains)
Clyde 😆
Re: Hotpoint Aquarius Extra WMA37 – Leak from drum
Don’t forget about your 5 year parts guarantee with hotpoint. all you will be charged is £89.98
Happy new Year
Clyde
Re: Beko freezer in garage – not cold??!?
Some fridge/freezers have a low ambient temprature switch wich will bring on a small heater inside the fridge to help it work correctlyin a cold location. I know servis have this in certain models but i dont the model no’s! 😆
Clyde
Re: Dyson washing machine stuck in test mode
I’ve heard about this before, display models are exectly that – for use in a shop. a company i used to work for sold some ex display models to customers and dyson engineers had to go out and change the pcb’s to properly programmed pcb’s! 😮
Re: Hotpoint FF91 Mistral Fridge/Freezer
The evaporator thermisor is most likely at fault part no 2601683. It doesn’t like moisture can provide dodgy readings!
if you do a resistance check of the thermistor the approx readings should be
+20’C 3K ohms
0’C 9K ohms
-5’C 11K ohms
-20’C 26 K ohmsHope this helps
Clyde
Re: Blomberg 1501 AAA vibration
The whole bearing assy is available under part no 55×5839, but check the cross peice for a green coloured spot as there is 2 different sizes available under the same part no!, a yellow spot on the cross piece is generally for the 1100 machines and a green spot is from 1300 -1500 spin machines.
