Forum Replies Created
-
Posts
-
Re: zanussi 1465 w 914792705/00
Door Lock Fault error 41 Door safety interlock faulty; Wiring faulty;Circuit board faulty.
Re: Hygena APM6012 PCB and lampholder
I have only done one and the light was on but otherwise dead – replaced board and all worked ok afterwards
Re: AEG W/d L16820 no power
The program selector switch also has the mains wsitch built in, have you checked this. Let me know if you req the circuit diagram
Colin
Re: What’s the most stupid things customers say?
Just had a customer call – says its a recall from 5th September last year where I cleared the blocked wash arms along with the filters, says he hardly uses it and has never cleaned properly since my last visit.
Offered a call for Monday morning – His reply ” That means I got to wash up all week can’t you come today”
A couple of years ago I had a couple of messages left on the answerphone very early one morning, an elderly woman saying that she had loaded her washing machine and it refuses to start so the call is urgent.
Returned her call just after 8am and said that I would call in that morning – Her reply “No you cant come today as my washing machine’s not working and I have to do it all by hand”
Re: Zanussi Cooker model ZCM5200W, 94771008600
Let me have your email and will send you a copy in the morning
Colin
Re: John Lewis JLDV08 Heating isses
Have you got or want the correct test procedure for this, if so let me have your email
Re: John Lewis JLDV08 Heating isses
Have you tried the diagnostics on this and are you testing with damp/wet clothes inside ?
Re: tricity bendix dh 103
Yes electro mechanical – let me have your email and i will send wiring/circuit diagram later
Colin
Re: Beko Dishwasher DWD5410W
This should help
Select program position 2 while the DW is off then press the start button and energize the DW and keep pressing on the button for 3 seconds.
All of the indicators turns on for 2 seconds after entering the test mode.
After entering the short program mode, press “start” button and begin for the short program. Short program follows the steps below.
1. Draining (15 seconds)
2. Water inlet (4.4 lt)
3. Water circulation , regeneration (60 sn),
4. Detergent (60 sn), heating (to 65° C) .
5. After reaching 65° , stops heating and water circulation. The water inside is discharged for 30 seconds.
In the case of any fault formation, the fault is shown by the program following lights. :
All lights are off No fault
Washing light is on Water inlet or water counter is faulty
End light is on NTC is faulty
Both lights are on Heater is faulty
All of the lights blink after the functional test finishes in the case of no fault occurredRe: Hotpoint T/D – TDL54 – [Wiring of new reversing timer]
Let me have your email and can send details
Colin
Re: Bad Integrated Appliance Installation
Went to a very none understanding customer on Friday with a Bosch integrated dishwasher, fantastic kitchen that looked hand made but the only problem was that the dishwasher was fitted hard against the granite worktop, plinth integrated into the units so unable remove and the machine is mounted on the floor that is approx 3 inches lower than tiled kitchen floor. The socket that was mounted behind the water softener had burnt out, but i was unable to get to it due to the plumbing.
Re: Lamona hja3220 oven
Have you checked the terminal block on the back of the oven – I have had a couple of these burn out
Colin
