Forum Replies Created
-
Posts
-
Re: Removing oven door – Indesit Oven FM1 IX
Ian, have a look at the Bosch website explanation here:
http://www.bshappliancecare.com/Bosch/Bosch_20773.html
There’s a couple of short videos there about it, one of them should be pretty much like yours as there’s only a couple of types of hinge generally used.
Dave.
Re: help with diagnosis on a whirlpool washer dryer
The tacho generator coil I think Martin 😉
It’s more likely a short there would have damaged the power control PCB than the timer.
By the way, this is a Smeg manufactured appliance.
Dave.
Re: Got a Digital Camera?
Send the pics to me or kwatt please Kenny, only admin can upload to the gallery 😀
Thanks.
Dave.
Re: Diplomat Select 610
Sourface, if you can post the model number from the rating plate please (should be around the door(s)) beginning APL or AHY or similar, I’ll check it out for you.
Dave.
Re: BernsteinFridge Hinges
That is the correct one in the shop in that case Jill 😀
If it’s lower right, the one you need is 246009700.
Dave.
Re: two door 14 year old AEG:water dripping from freezer doo
Yep, the drain hose from the fridge to the tray on top of the compressor is blocked.
At the rear of the fridge where the ice forms, when it defrosts it runs down in to a channel then via the hose/duct to the tray on the compressor to evaporate. If the hose/duct is blocked, the channel overflows, hence the water under the salad bins and then runs down via the door seals on to the floor.
Check that again, I know you said it had been, but I think it may solve your problem 😀
Dave.
Re: two door 14 year old AEG:water dripping from freezer doo
Is there any water under the salad nins in the fridge ?
If not, then it does look like an insulation related problem, especially given it’s age.
It may well continue to operate like this for some time, apart from the obvious dripping water problem.
Dave.
Re: Smeg FC40RX fridge/freezer
Try these:
Paterson Quality Services Ltd 0161 4773725
If you decide to use them, please let them know where you got the number.
Dave.
Re: Samsung SR-608EV, suspect refrigerator fan fail
Alan, South Glos wrote:Could the problem just be due to icing up
Possibly, although you would normally expect this to happen to a fan in the freezer compartment where the ice is formed.
Alan, South Glos wrote: if so how best to cure?
Switch it off and let the whole unit defrost for 24 hours with the doors open and try it again.
Dave.
Re: Smeg FC40RX fridge/freezer
I would suggest you switch the freezer off altogether, the thermostat for the freezer compartment should have an off position normally.
No you can’t test them, they are sealed units, wait for an engineer please;)
Pop up your postcode and I’ll check the directory for you, there may be someone here who can get there more quickly.
Dave.
Re: Heater element for a CDA washer/dryer
Leave it with me for a minute, I have to phone them anyway today 😉
Dave.
Re: Heater element for a CDA washer/dryer
Nick18 wrote:Does this lot mean anything to you and if so is the part available?
Just the model of the appliance please is all that is required (on the front normally).
I don’t recognise any of those other’s 😕
Dave.
Re: Blomberg 1301ABB washing m/c door seal
Price direct from Brandt is £28.95 inc VAT and delivery Nigel.
If you want one ordered up and sent on to you, drop me an email to spares@ukwhitegoods.co.uk
Dave.
