[delta01]

Re: hpt 30mm bearing kit

thanks guys i think i will investigate the option of the local bearing suppliers i will take a gen kit along to see what the prospects are and will post any success if any

[delta01]

Re: creasing

thanks for the input guys, i think the problem occurs after spinning, i asked customer to check if hoses were on right way, and am awaiting their response

[delta01]

Re: creasing

wd61

[delta01]

Re: hoover hp13

hi again , yes both valves read ok on ohms range about 33.5

this fault developed after removing the heater to extract a bra wire , although the customer didnt report the fault for about a week afterwards probably just coincidence but baffling !

[delta01]

Re: hoover hp13

hi again it fills through the valve nearest to middle of machine , ie the right hand side of the double valve looking towards back after about five minutes of motor action

[delta01]

Re: hoover hp13

yes the very same, i got the correct module eventually (digital)
i will check how it fills soon and get back to you, thanks for your input

[delta01]

Re: hoover hp13

i got three flashes according to code book this is pump timed out, however. the machine is empty i tried changing pressure switch to no avail, is it possible for the spin potentiometer to cause this fault ?

[delta01]

Re: hoover hp13

well it seems that there are more than one board for this model as a tel call to connect revealed, surprized that yet again none of the engineers on this forum could offer that solution, most questions i have submitted has generally drawn a blank or some wrong suggestion, i’m sure some genuine help has been offered by some ,but get the feeling there is a reluctance by others to offer genuine help ,

[delta01]

Re: hoover hp13

i havent tested them i will check that though. strange thing about this is the original fault was just a bra wire in tub , i removed the heater to extract it and all seemed ok, later the customer said it had not spun so after a quick look over i thought best to bring it in , concluded it must be the board

[delta01]

Re: B&Q at it again

maybe the fact the vat man gets a cut on every sale has some bearing on the situation too

[delta01]

Re: Zanussi DE6854

thanks guys it was a dry joint sorted

[delta01]

Re: Zanussi DE6854

hi guys i have exactly the same problem with same model d/w could you advise please

john

[delta01]

Re: ariston ls161

sorry i havent seen this job i was asking on behalf of a local engineer, i am trying to get him to join uk whitegoods, but i will ask him re your suggestion thanks

john

[delta01]

Re: ariston ls161

start switch is to left of on off

serial no 907210701

[delta01]

Re: corrosion…. never seen it so bad

yes it was the thin type, i dont know how it held together long enough to end up like it did

[Author]

Posts