Forum Replies Created
-
Posts
-
Re: Smeg Dishwasher UKSTX1 No go
Bob, if you have got 240v to the transformer on the board then it is the board thats duff. Not a common failure on these but sometimes the customers leave them switched on always and the transformer will eventually cry enough.
Re: neff/smeg v5360 washer dryer no motor action
It is a smeg, prone to shedding belts on uneven loads. Motor plug wires breaking and of course the usual stuff, Brushes etc.
Re: Diplomat dishwasher no heating
Could be a number of things from a faulty heater to wires broken in the door which is very tricky to repair safely. Not really a diy job.
Re: Anyone fancy an electric car???
johnmac11 wrote:Just noticed a story on Yahoo regarding a new electric car. Went to the manufacturers website to see if the specs were kosher and found this,
http://www.zapworld.com/ZAPWorld.aspx?id=4560
Look at the specs for acceleration, top speed and range, I can see Mark getting rid of his Clio 😆
JohnIt runs on Windows XP-already outdated!
They can claim all they want, bet it wont deliver though.Re: Pattern Heaters: A cautionary tale 🙁
You guys obviously dont remember the old Zanussi SL heaters, Absolute pigs and would slit your wrist on the back panel opening at the same time. I think newer machines are easier to remove heaters, its just the plastic drum construction allows little scope for leaverage.
Re: Baumatic BHD 6/1 diverver valve
Thats a Brandt part, common failure too 32X1675 should be the one, look at the pic on connect.
Re: Diplomat adp8234 facia panel clamps
If the facia is cracked anyway, order 993736190 complete facia with all the clamps complete.
Re: STOVES slot in COOKER — 059041927
could be the pilot connection on the grill energy regulator isnt completey switching off. Disconnect the the wires from the grill reg to prove this. Think the 2 faults are related. If not then it will be the pcb which times the cooling fan.
Re: Whirlpool G2PWD3
tricky one, so many differrent doors. AFAIK the latest 1600 rpm ones use 695260053 (listed as 300mm, but measured where I have no idea)while the 1200 use 695260059 what the difference is I do not know. These are listed at 68.29 retail.
Dont know of any sure fire way to convert part numbers.
Hope that helps.Re: G B DAR ltd
They pay well and on time, great rates, parts cheaply priced, quality machines to work on, parts arrive quickly and accounts are efficient, you can call on their customers as and when it suits you, easy going attitude…..its April 1st! dont go there, read the threads posted by Don and make up your own mind 😆
Re: AEG DISHWASHER.. E30 FAULT
Re boot the microwave (un plug and then re connect) often it works, dont ask me why.
Re: Smeg DWI710E1 4 to 5 hr to complete a wash
Depending on software, these dishwashers either do a continuous pump with intermittent bursts of fill for a good 2/3 minutes before the fill proper starts or, the other version is intermiittent fill and intermittent pump for a few minutes. You need to let it complete this sequence before diagnosing the problem.
What I meant by “just off boiling water” is really hot water but not quite boiling. 😉
the non return valve is either in the pump outlet or in the inlet of the pump where it pushes into the sump.
the Coil reference referred to the dispesner coil.Judging by your description its a classic E2 fault, remove the meetering tank/air break, its only 2 screws and the breather ring inside and give it a good clean, especially the passage through the softner which ends up at the flap at the back of the sump.
