Forum Replies Created
-
Posts
-
Re: AEG hob base glued to glass
leavemetogetonwithit wrote:Exploded views available on electrolux.co.uk spares shop. Sounds like sealing strip has got old.
Mike.thanks but I know where the explodeds are……..ordered 2 very expensive rings for it! Short of levering against the (obsolete) glass I can find no way to remove the base. Non standard size hob, customer only recently had new kitchen and work top cut to suit old hob.
oh dear, have we really sunk that low to have an xfactor thread on here? what next a strictly cum whatsit one as well?
Re: “Ah yes, you’re the lady with the BIG….”
you dont see many of those on the road yet alone the same driveway, eccentric family by any chance?
Re: Repaircare in BTCC
Well Martin Depper destroyed his car in a start line shunt at Silverstone today…….expect a few debit notes in the post in the morning 😆
Re: Has this site been mentioned on here before ?
hey, babe in a Ramones tee shirt repairing her own machine!
Re: smeg ceramic hob
part number was 762810749 but this fault normally occured after the hob has got hot so you cannot turn the heat or anything off without shutting the power off from the wall, if yours is a bad contact even when cold it may not do the trick, the touch panel is easily removed from underneath I would have a good clean of the underside of the glass and ensure a good contact between the pads and the the glass.
Re: smeg ceramic hob
there was a mod for some of these which involved spacers under the control unit pushing it harder into the glass and making it less likely to flex and droop down when hot. Model number will be on the bottom where they are on all hobs. someone removed it maybe?
Re: Spam
eastlmark wrote:Ade, stop spamming this thread!
just joking you mate, should have added a 😆
Re: whirlpool AVM965/1x microwave/ cooker hood combo…….
johnmac11 wrote:Was the microwave dead??
John
was when I had finished with it!
surpisingly hood functions still worked…….but turntable going around constantly was not a good sign, so I pulled the leads to the microwave.
Re: whirlpool AVM965/1x microwave/ cooker hood combo…….
suppose I should describe the fault seeing as we have a couple of “experts” here. shut door and light and turntable come on before even setting any time or power settings, turntabe will run until plug is pulled. Did have similar symtoms on panasonic microwaves before with door switch shorted out, would have checked the door switch if only I could get into the damn thing.
Re: whirlpool AVM965/1x microwave/ cooker hood combo…….
johnmac11 wrote:Quality machine… did you have to take it off the wall :rotfl:
John
yes! and then they made me put the damn thing back again to cover the unsightly gash it left.
and chezza, never mind the worktop, its the induction hob beneath that worries me!.Re: whirlpool AVM965/1x microwave/ cooker hood combo…….
next time I go on one I must remember to take a can opener…after 150 screws removed I still found myself peering under bent up bits of sheet metal, covered in grease and still no further near finding the fault, fuming I am!
Re: Help smeg door required cooker
showing as NLA…..this is the black one , right?
would have a word with servavast:
http://www.smeg-service.co.uk
