Forum Replies Created
-
Posts
-
Re: Football Season 2013/14
Just back from a near 600 mile round trip to Bournemouth, where a below par clarets team were held to a 1-1 draw. The pitch played a big part in the game, but we still managed to earn a point, despite key players not performing to 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}.
We need Reading to help out v QPR tomorrow.Re: Liebherr Fridge freezer F2 fault.
F2 is fridge evaporator sensor fault. The part number you have is correct.
Re: Viceroy dishwasher
hi Mark, call Malcolm @ DMK and he’ll supply the loom if the customer is going to have a repair.
Re: Football Season 2013/14
I thought andy would be all over this thread!
Who’d have seen that coming? I didn’t watch it unfortunately.
Meanwhile at fortress turf moor, the clarets are still unbeaten since last march after a comfortable 3-1 against Millwall.Re: Baumatic BD1613 (D/W)
Hello John, have you looked at the anti flood switch or wiring at the bottom of the door?
Re: Football Season 2013/14
Yes Don, those are the sort of games I like to watch. Just wish it was nearer. Excellent goal by jay rod yesterday.
Re: Football Season 2013/14
Yes, I felt we had the better clear cut chances. They didn’t get behind us much. Ings, Kightly and Stanislas could have put us further in the clear.
Going there and getting a point is something I’d have taken before the game.Re: Football Season 2013/14
Not a bad display from the clarets today, in a 3-3 draw away at QPR. We created some good chances and could have nicked it, but just couldn’t hold on to the 3-2 lead.
Re: Will a VT9 thermostat adequately replace a K57 P2018?
Hello, the vt9 stat should be suitable for a wet wall evaporator.
The vxo stat turns off at a higher temperature. I’d go with the vt9,Re: Liebherr GN2856 nofrost
I saw the reference to $ but assumed it was a typo.
whereabouts are you?
is the appliance 240v?Re: Liebherr Fridge Door Hinge Pin Stuck Inside Door
Hello, so if I understand correctly, you have a length of hinge pin stuck inside the door with no way of gripping it to pull it out?
If so there are a couple of options that spring to mind. Get some strong adhesive, such as araldite and glue something to the bottom of the pin. When it’s set, pull out.
Drill the bottom of the hinge pin with a fine drill, screw in a self tapping screw and pull out.
Let us know how you get on.Re: Liebherr GN2856 nofrost
Hello, as discussed earlier, you won’t get a resistance reading from the fan. You’ll also not get voltage at the fan with the door open.
The evaporator sensor is always going to be colder than the air sensor because it measures the temperature of the aluminium evaporator and not air.
It’s the air sensor that has to be a couple of degrees warmer.
Of course the evaporator should be cold enough with the door open. Set it running, leave it for a good hour or two and then check it.
Part number of both sensors is 9590148Re: Liebherr GN2856 nofrost
the sensors are not expensive and by far the cheaper option of all the rest.
you can obviously simulate the door being closed by offering a small magnet to the reed switch. that way, with the door open, you would be able to hear properly. you could also check for voltage at the fan, thereby confirming your diagnosis.
other than on the board, there isn’t another switch for the fan and in practice if the system is ok, it should run after 15-20 mins or so.
