Forum Replies Created
-
Posts
-
Re: PCB type thermostat compatibility ?
try
http://www.4ourhouse.co.uk/pcb/product. … BFFF55152b
seems to be listed for your model
BUT this is only the board and not the temperature sensor
Dave
Re: Whirlpool super capacity dryer
also Qualtex seem to list the kit
481201230215
seems like a special order but if you ring them they can ring whirlpool to see if they have uk stock
Dave
Re: Cda226ss grill element
dont think your model is correct as i cant find it
try
1 site shop https://shop.ukwhitegoods.co.uk/
2 elementman http://www.elementman.co.uk/
3 http://www.cda.eu/you can try ringing CDA but i would check the model first
if all else fails you can prob get one made
Dave
Re: Bosch washing machine new brushes fitted
never had to file the edge of the brushes, they are a bit tight till they get to about 2 mm from the bottom but i assume thats so they can be released after the motor has been put together.
no I mean the actual face of the brush that contacts the armaturemost of the time any damage on the main board will be visible. blown tracks etc
since you had to reconnect the wires i would do a resistance reading from the pcb. see if you can find Armature. field coil and tacho before you start deciding the board is at fault
Dave
Re: Bosch washing machine new brushes fitted
dont know of other peoples problems but not had any bosch motor problems in ages
the only problem i am having is the replacement brushes. Am using the Qualtex car93 brushes and am finding they are not manufactured properly. What I find is if I just fit the brushes they will spark excessively. If I then remove the brushes instead of the wear being in the middle of the head it is at the tail end so i have to emery this edge before i install them.
I am assuming the the angle of the head is formed wrong in manufacture. I must order a gen set to check one day.
What it does mean is I have to spin the machine and remove and redress the brushes to make sure the sparking does not damage the motor. Also I tell the customer to use a lower spin speed for the first 10 washes and don’t load it full of towels to give them a chance to bed inDave
Re: flavel milano 100 cooker
thats not the correct model but its probably a Beko in which case its at the back of the oven on the right looking from the rear
if you have model or prod code ( prob starts 772) i could look up the part number
Dave
Re: BOSCH Classixx not condensing
if it was a simple blockage i would have expected the machine to cut out when the sump became full or at the very least start leaking the overfill water on the floor
Dave
Re: Bosch washer dryer WVD24450gb cuts out power
if you are certain the power to the machine is ok ( live and neutral) then its most likely the board power supply
Dave
Re: Miele Fault Code F70, possible faulty non return valve?
its as valid a theory as anything else but only close investigation will tell you the answer
Dave
Re: Miele Fault Code F70, possible faulty non return valve?
you have leak. you have to run the machine with the sides off and look for it
when you have found it you can try to fix it
dave
Re: BOSCH Classixx not condensing
if the clothes are drying the water must be going somewhere and if its not in the draw it must be leaking out of the seals into the case and into the surrounding air. if it was cold outside i would expect condensation on your windows
Dave
