Forum Replies Created
-
Posts
-
Re: Smeg burner won’t stay alight…..
search on this site for a local independant engineer who repairs gas cookers
Dave
Re: Miele door lock W/M
dont know why you fitted gen seal as you can get a non gen for about £10
sounds like the rubber may not be fitted correctly round the door. hope you dont need a new lock that would not be cheap
Dave
Re: Hotpoint FFAA52 Not Working
this where my lack of info stops me but from what you say it sounds like the compressor went pop or the circuit board got wet. if its the compressor then its scrap
DaveRe: Andy Trigg tells the Daily Mail
well if anything needs to come out of that its the need to register all new appliances so if there is a recall they can be found
does not stop rubbish design all that t drier needed was an old fashioned microtemp set at a very high temp so there is no way it would blow unless of severe overheat
Dave
Re: Bosch 1200 Classixx Express door sometimes won’t open
well 2 poss probs spring to mind
1 heater if there is a slight earth fault on the heater it upsets the electronics and wont finish the prog. try disconnecting and insulating the wires to the heater and run a rinse prog
2 the pressure bell blocked. the water height is decided by an air pressure switch if this is sticking or the tubes are blocke it will think there is still some water in the machine
(be careful if its a late machine you can destroy the switch by blowing in it)Dave
Re: Smeg burner won’t stay alight…..
if the thermocouples are the same as another ring swop them and see if the fault moves too
Dave
Re: hoover VHD 964 ZD
old machines used to do this if the pressure switch was stuck
beko do it if hot and cold pipes are crossed
not had it with this machine
Dave
Re: not a lot to show for 36 years
sorry to hear that m8 can imagine the wounds are a bit raw at the moment. with luck you may be able to buy some of the old stock as it useless unless you are in our trade
best of luck for the re-launch
Dave
Re: Hotpoint intermittently not draining
most likely the pump
had a few do this. will run with no water but wont start when full
Dave
Re: No Power to PCB
it will be the pcb the only thing now is can it be repaired or will you have to replace it
Dave
