Forum Replies Created
-
AuthorPosts
-
electrofix
ModeratorRe: Neff oven tripping when it goes above 160 degrees
most likely the element
Dave
electrofix
ModeratorRe: Replace AEG Competence B1180-4 knobs
most knobs just pull off
i need more info to give you a knob part number as there are 10 ovens with a similar model
you need to see if there are any letters after the model also there should be a product number starting 94418Dave
electrofix
ModeratorRe: Smeg S30strp/1 Water appearing on floor
main Smeg spares provider
http://www.servevastdirect.co.uk
did look and no parts are listed for your model. if you ring them they will give you a part number so you can web order
Dave
electrofix
ModeratorRe: Beko ODF22300x – heating when it shouldn’t
do they have an RCD ?
if no have you checked for earth faults ?
Dave
electrofix
ModeratorRe: Beko ODF22300x – heating when it shouldn’t
must be something wrong. either wiring or wrong switch
have sent you wiring diag
Dave
electrofix
ModeratorRe: Start/pause button beko tumble dryer
there is a plastic frame behind the buttons
part no 2963670100 ( light guide set )
they have a habit of snapping and causing this problem
Dave
electrofix
ModeratorRe: fisher and paykel dishdraw overfills
wondered what that was for
will take a look thanks
Dave
electrofix
ModeratorRe: fisher and paykel dishdraw overfills
is that like a small silver metal peice ?
Dave
electrofix
ModeratorRe: Bosch slimline dw SRS56A02GB/08
has this one been modded by bosch
go to
http://www.repairaction.co.uk/bosch
put in Enr and Fdwhen i guessed the Fd is told me to ring bosch
if i am correct then the timer blows internally and may well cause your fault
if it has not been modded and needs it its a free timer change as far as i know
Dave
electrofix
ModeratorRe: Bosch HBA63B261B/45
all triacs on any module will leat out to a wire that supplys power to something. if they are power transistors then they control relays or some other board component
trace the board tracks to see which they are.Dave
electrofix
ModeratorRe: CDA WC130 (Whirlpool) Dishwasher strange fault.
some of the units have a turbidity sensor. not sure if yours does
Dave
electrofix
ModeratorRe: Indesit pressure switch
had a few of this problem where the pressure bell was integral part of tub and blocked
I found if I poured about half a bucket of water in the drum, then disconnect hose from pressure switch, then blow and suck the water in and out of the bell to try to wash it out as best u can. it may not clean it completely but its cheaper than a new drumDave
electrofix
ModeratorRe: Brands
As for the light activated bleach last i knew was it was only 1 major brand that had the patent and all the rest could not use it
remembering the ukwhitegoods training days
unless anything has changed since then
Dave
electrofix
ModeratorRe: Neff Combi Microwave – help please
does sound a bit like a board fault. have you checked for relays for leg joint problems?
you could ask QER if they repair this board
electrofix
ModeratorRe: Smeg burner won’t stay alight…..
are the flames on the other burners the same
ie do the flames miss the thermocouple ?
Dave
-
AuthorPosts
