Forum Replies Created
-
Posts
-
Re: De Dietrich DVH640JU1 Dishwasher
or the power module
would have to see how its flashing but if its like the hotpoints where they all flash together it may be a power supply prob
i would check the power board for blown caps. i cannot see what type of power supply this board uses but if its not switch mode like hot wma machines that may be suspectDave
Re: Beko WMB 71442S
well first off i would open the filter and check the pump.
good chance you will find Hairclip, bra wire, curtain hook or others jamming the pump impellor
remaove filter and get down with a torck and look inside. make sure there is nothing jamming the impellor ( white cross)
beware if you remove filter and the machine is full of water you may end up paddling
Dave
Re: Beko DCU8230
mine is different model DSC85w
looked up on beko technical and there is a bulletin re the elements. they changed the thermisor old one is grey new one is white. according to sheet the 2 are not interchangeable as the main board is different in each case
since my customer had got his own element and its the wrong one i cannot say for certain why his unit is not heating. played around swopping thermistors to hotpoint ones. linked old thermistor in circuit but not touching earth still no heat.
in my case customer would need correct pcb and correct heater or maybe just correct heater.
he is going to contact espares who obvoiusly dont know there are 2 elements and see if they will swop it
DaveRe: aeg dishwasher installation query
there are about 11 dishwashers bearing this model ( need product number to get same one ) but the one i checked used the standard brackets
google image this number 1172870014
they fit top left and right and allow you to screw to worktop or cupboards
Dave
Re: Bosch WFL1880 – not filling water properly
motor brushes gone most likely
the clicking is the relays on the board reversing the motor. you dont hear them when its running normaly
Dave
Re: John Lewis Condensor Tumble Drier JLTDC03 no heat
with a 3 beep fault is it saying the conductimetric sensor is not right
as far as i know its should be the sensor circuit that detects moisture in the machine
suggested faults are wiring, brushes or main board fault
think you may need a professional with knowledge of the test proceedures
Dave
Re: Belling BL325 thermostat
did not look closely only saw the stats and posted to let you know
try email the seller to see if they know if its compatible
Dave
Re: Beko DCU8230
it will need ntc as board needs to sense it in case of failure
my customer has already fitted a new heater before they called me
Dave
Re: Hotpoint stuck on drain?
may not have seen this fault on these but have had countless triac failures keeping pumps or valves on
worth a check it may be sensing the wires to the pump before startingDave
Re: Bosch Exxcel WVD245S3GB/01 bearing change advice
the bearings are housed in a metel spider mounted on the back of the drum.
it is possible (but not easy) to remove the spider without removing the drum and withdraw it through the back panel
bosch supply the bearings as a complete spider part no 283726 but at £163 its a bit expensive. you can buy non gen bearing kits very likely from site shop.
if bearings have got to bad it will have damaged drum spider, so strip it and check first
you can see a breakdown at http://www.bosch-home.co.uk/store/spareparts/searchDave
Re: Beko DCU8230
got a similar one at mo but yet to go round armed with Beko info
going tomorrow so will see
on mine i checked relays on board so i know its not a relay failure
Dave
Re: John Lewis washing machine E10 error
the last 4 mins of any cycle is spinning so it should be pumping out
Dave
