Forum Replies Created
-
Posts
-
Re: DW2677/2 (854567715880) stopping mid cycle with 3 beeps
does it stop and go dead or try to start again ?
Dave
Re: Hotpoint BHWD129 washer dryer – door stuck
one of the problems with these boards is there are 2 of them. so 1 or both may be faulty. if its under 5 years you may be able to claim on the 5 years parts warrenty (but you have to pay hotponts labour charge) or send both boards to http://www.emwelec.co.uk/
they can then test and repair as a pairDave
Re: Bosch Exxcel WVD245S3GB/01 bearing change advice
you have got to take a lot more than the access panel
remove the tumble dryer section including the condensor which runs down right hand side
as said its not easy but it is doo able
Dave
Re: Hotpoint BHWD129 washer dryer – door stuck
could be the pcb units on these machines are live 24 hours a day so tend to go
as a long shot
turn off at plug
find the wire that connects to front panel from the main board below
remove it ans replace it to clean contactsswitch on and try again
just thought it may have got disturbed with your hands inside
Dave
Re: Hotpoint BHWD129 washer dryer – door stuck
no but since you have been playing door may still be locked
select a pump only cycle start it and let it finish (listen for door lock going clunk)
then turn off and unplug reach down inside behind the door lock. feel for the metal hook that is on the door. push it to the left ( i normally use a small screwdriver or a 2 inch screw to help) its quite stiif as you are pushing against a spring
once the door is open dont close again. it will be the door handle in the door that needs replacing
dave
Re: Elica star hood (glitterball thing)
owners manual
http://elica.com/RU-en/products/hoods/star
Dave
Re: Whirlpool 2000
site does recognise numbers but you missed a 0 off the end
12nc number is 854139615050
but there are no docs listed but one you search the number hit request and ask them to supply or email them
Dave
Re: fisher paykel dish washer(2 draw)
to remove the draws pull the pins left and right hand sides lift slightly and pull
with pins out you can remove front. run dishwasher check both activators are pulling lid closed to sealdave
Re: 6inch 6 point fan oven blade
there is no such thing as a universal fan blade. there are some manufacturers who sell them seperatly
Beko pt no BE116100007
zanussi 50240853007but these do not fit all models. you do not say what you want it for as these seldom fail in ovens
could you use fridge fans. these clamp on motor shafts so are easier to fit to a straight shaft
Dave
Re: hotpoint tvm570 not reversing
very likely
to you have 2 wires going to the capacitor from the timer. the timer send a live to wire 1 for one direction or a live to the other to reverse it
Dave
Re: Beko wmc6120w Leaking
if machine id filling up between uses there is ony 2 ways it can happen
1 inlet valves machine will fill with clean water much like a leaking sink tap with the plug in. therfore you will find it full of water
2 drain hose backfill from the drain hose due to bad plumbing. machine will fill with dirty water from sink. raise hose to stop it
Dave
Re: aeg dishwasher 65011v1
from tha manual i have pm’ed to you fault 60 only comes up to customer if its an overheat problem
Dave
from tech infoselect half load when using any programme (exept pre wash ) to save water elec and time if machine is only half full. place dishes anywhere in machine upper and lower baskets
Re: Washing Machine DNY 7144 DIX – Hoover
think you may have model number wrong
but
i would search the net some sellers put various pictures on that may help you
or have a day out at currys to checkDave
