[electrofix]

Re: Neff Hood D8900N0GB/01

dont know on this unit. some are controlled by electronics some by simple switches
if it simple switches then track blow in there. if its a seperate board then look there

Dave

[electrofix]

Re: Leisure HJA5100 – Clock fault

this is a simple timer so no should not be affected by stst

but you can also bridge out the clock if you dont want it. the wiring diag show 2 red wires if you join these and disconnect the blue one oven will work with no clock

part number of timer should be 267100063

Dave

[electrofix]

Re: Hotpoint seal

ah yes forgot about that one in the old bearing seals. its a wonder it lasted this long the early seals were not reliable

Dave

[electrofix]

Re: Hotpoint seal

where is this spring holding seal on drum or holding it round door

Dave

[electrofix]

Re: bosch exel 7 1200 express

are your brushes sparking ?

also dont feed heater unless there is enough water in it

Dave

[electrofix]

Re: Vintage Prestcold 431

still got a GEC coldspace 43
(like one pictured below) only taken out of service last year. still runs and freezes well

not sure how old it is but it was bought when in a previous house and we left there in 1970

Dave

[electrofix]

Re: Neff Hood D8900N0GB/01

if the fuse in the plug is 13amp then you have probably blown a hole in the printed circuit board

it is common for kitchen fitters to leave the 13A fuse in the plug or spur box and ignor the manual which asks for 3 or 5A

Dave

[electrofix]

Re: bosch wae24364gb/19

sometimes

check the fusible resistor on the board around 100 ohms

if its gone may be just the resistor or the power supply chip as well

Dave

Dave

[electrofix]

Re: Washer/dryer screaming: Hotpoint BWD129

something caught between the drums

or

drum failure

Dave

[electrofix]

Re: Whirlpool ADP7409

cant find a listing for the ntc in your machine but there is not many places it can be

normally with most dishwashers its either in the sump or in the door in contact with the metal

[electrofix]

Re: Smeg DI612

agree
its the bit about the soap draw solenoid

Dave

[electrofix]

Re: Smeg DI612

trade-technical/known-error-codes-t40-30.html

Dave

[electrofix]

Re: Hotpoint BHWD129 washer dryer – door stuck

if it wont fit because of height ask if the do a kit to lower it

bosch do they make a build under kit that removes the lid and replaces it with a steel plate (think its still made )

Dave

[electrofix]

Re: Trinity Bendix Oven Selector Switch Puzzle!

model is TBF610X

part number you have is correct

no sign of any bullins re this switch

have added picture from qualtex cant be sure its the actual switch but it may help

Dave

[electrofix]

Re: Beko CDA539FW-2 Thermistor Values

typical Beko

the parts list says it a pcb design so does circuits but tech spec says its a ranco stat

so cant help

Dave

[Author]

Posts