[electrofix]

Re: kenwood dishwasher kid60b12

you say fills with water then discharges is the main wash motor tring to start and does not

think this is a vestel made machine as i cant find it under Beko

Dave

[electrofix]

Re: John Lewis washing machine E10 error

is the water actually being pumped out or is the outlet hose too low allowing it to syphon ?

Dave

[electrofix]

Re: diplomat adp5520 installation

because the hob is gas

the max load is 2 ovens or 1 oven and a grill (assuming 2 cavities as i can find a picture of the unit. if 3 cavities add 2Kw)

assuming 2Kw per side and 4.2A per Kw thats a max load of 17 Amps (if it only had 1 oven you could use a 13A plug)

Dave

[electrofix]

Re: Bosch SMS53E12GB/01

if you type “bosch E24” in the search bar lots of stuff comes up

Dave

[electrofix]

Re: Hotpoint FDL570 Dishwasher wont turn off

if water leaks into the base it operated the flood defense. this makes the pump run non stop and the machine wont start

you may have a leak or it just may have had a bad day. drain base and run to see if fault re-occurs. if you can see into the works while its running look for leaks with a torch

Dave

[electrofix]

Re: HOTPOINT WMD940

put a long screwdriver through the door lock and hold against door seal. with the spring going outside (right) of driver it stops it slipping off.

hold screwdriver with knee and you can stretch spring round

Dave

[electrofix]

Re: help please

most machines do not have internal fuses. form what i can see of this machine it is at the bottom of the market full of cheap and unreliable components
if its not the cable or lead then its probably the main board thats failed

you will have to get it checked to be certain

Dave

[electrofix]

Re: AEG Dishwasher not filling,

have pm’ed you some info

Dave

[electrofix]

Re: STOVES 900EF CLOCK

look for the relay on the board thats normally the give away

or post a picture and somone may be able to help

Dave

[electrofix]

Re: Hotpoint FDYF11011 Issue

had a few hot dishwashers where the switch itself failed on the board. if they are about 4mm square then its poss to replace or clean. if they are smaller its a whole board and its a silly price

cant find a board pic for your machine so cant be certain

dave

[electrofix]

Re: Larder Fridge Door Slider

not sure what your after but

go here
http://www.bosch-home.co.uk/store/spareparts/search

put your full Enr in and see if you can see it

Dave

[electrofix]

Re: Smeg SUK65MF (Duel fuel)

it sounds like an overheat stat is activating. dont worry about light those lamps will light easily its prob a back feed caused by the overheat stat opening

Dave

[electrofix]

Re: Samsung washer dryer wd0804w8e/xeu water inlet hose faul

i was thinking more like this

http://shop.ukwhitegoods.co.uk/fwh18-1- … inlet-hose

Dave

[electrofix]

Re: Samsung washer dryer wd0804w8e/xeu water inlet hose faul

this is an external water limiting device. it has no connection with the workings of the machine apart from If the inlet valve sticks open it will limit the amount of water entering the machine to stop flood

if you replace it with a standard fill hose, you run the very remote chance of a flood, but the machine should work normally

there are thousands if not hundred of thousands of machine working out there without this device

Dave

[electrofix]

Re: How to open fully new Bosch hinges for NEFF B1320N2GB /

try this advice from Martin

Dave

[Author]

Posts