Forum Replies Created
-
Posts
-
Re: Miele W916 inlet valve version
the only difference in the valves are 2 of the coils are 110v
which water inlet valve do you need to replace?
if its the one in the grey case its very dear but if you get a normal inlet hose and connect it directly to the triple valve it will work . you will have to leave valve in the grey box connected electricaly or the machine wont work
Dave
Re: Replacing Miele W504 brushes
holder has 4 plugs to connect to field coil 2 left and 2 right just need a bit of jiggling to get it out
when you put it back leave brushes captive in holder and when installed poke something down holders to release
Dave
Re: CDA Dishwasher WC130 (Whirlpool)
sound like a board power supply problem
see here
trade-technical/simple-pcb-repair-tips-t51155.html
for more info
Dave
Re: oven diplomat electrical prob g720 cooling fan prob
it lookes like a stoves cooker in disguise
think your problem will be the pcb and probably the pcb power supply as these tend to loose power over time like a battery running down
Dave
Re: John Lewis JLWD1404 Washer No Dry
have you checked water solenoid
dryer checks for water flow before starting
Dave
Re: Bosch WFO2473GB/08
if you look at other bosch machines for clues seem to be a heater fault on a few so thats where i would start
otherwise pm Nomad he has bosch infoDave
Re: Miele G7702
had a look and no cant see one
but it could be the water leak causing the problemDave
Re: Smeg Cooker A2PY/6 Timer
have checked website for model A2PY-6 they dont list the timer but if ring them for part no then you can order it
throughhttp://www.servevastdirect.co.uk
ring servast 01543 461352
DaveRe: Miele G7702
doubt it but does this help
http://www.nettoparts.co.uk/shop/drain- … 1276p.html
Dave
Re: Zanussi E20 error code, but it can drain…
switch off machine
hold start and pause button
switch on machine and wait till display and leds start flashing
then press wash select buttons to run through various tests
if you kepp pressing one of them will give you last E codeto get out of this mode turn off turn on then turn off again then your back to normal
Dave
Re: Zanussi E20 error code, but it can drain…
there are 3 fault codes associated with E20 but you have to be in engineering mode to find exact code
poss faults
blockages the machine senses water level through air pressure. this gets gummed up and has to be cleared out otherwise it causes an E21 fault ( you will see E20)the other 2 faults in this set are noramlly down to a pcb fault so not normally repairable cheaply
Dave
