Forum Replies Created
-
Posts
-
its not a fault i have ever seen or heard of
I assume it works no problem unless you try to time it
Daveif the pump is running all the time have a careful look at the triacs. l plus check for short circuited ones. you need to identify the one for the pump
Daveif it was inlet solenoid the light would not flash
think I would open the timer and check for blown components
Dave
if you check your owners manual it will say solid check water light is a water fill or drain problem but when it flashes it can be any other fault
and no easy way of telling which one
dave
the only difference is your measuring insulation resistance with 9v dc but the machine operates at 230v
the only way of being certain it to use a high voltage tester or you could remove the brushes and dust off the carbon dust
think one of the things i would do now is lift either t1 or t2 triac leg so you can see if its the triac giving the reading or the board
Dave
dont think its a chinese one
not very old is it
have you checked for loose connections. waggle plugs and see if display goes on and off. was thinking poss solder joint on the board plugs
Dave
when you measured the traic make sure you reverse the leads in case the leak is one way only
this fault could be a stupid as too much carbon dust on the brush holders causing slight earth leak
Dave
well cant help doing a complete check
check wash heater, motor brushes. dryer heater. then go onto thermisors
all can be done with a multi meter
Dave
